Network setup, Connecting to the network

Network setup

Connecting to the network

To enjoy internet services, you need to connect the TV to a router with a high speed connection to the internet. You can also connect the TV to your Home network server through a router or access point. The TV connection to the router can either be wired or wireless.

NOTE

•If you choose a wired connection to the router, you need an ETHERNET cable (commercially available).

•If you do not have a broadband internet connection, consult the store where you purchased your TV or ask your internet service provider or telephone company.

•An Ethernet and wireless connection cannot be used at the same time. Use only one of the connection types.

•A wireless LAN connection and performance cannot be guaranteed for all residential environments. In the following cases, the wireless LAN signal may be poor or drop, or the connection speed may become slower.

−When used in buildings made with concrete, reinforced steel, or metal

−When placed near objects that obstruct the signal

−When used with other wireless devices that emit the same frequency

−When used in the vicinity of microwave ovens and other devices that emit a magnetic field, electrostatic charge, or electromagnetic interference

•A stable connection speed is required to play back streaming content. Use an Ethernet connection if the wireless LAN speed is unstable.

•Please use Category 5 ETHERNET cable.

Wired installation

Use an ETHERNET cable to connect the ETHERNET terminal on the TV to your broadcast router as shown below. This is recommended when enjoying services which require stable connection speeds, such as streaming media.

EWired connection overview

PC

Router (commercially available)

ETHERNET cable (commercially available)  Network

EHow to connect

Router

ETHERNET terminal

LAN

ETHERNET cable (commercially available)

1Switch on the router (commercially available). Refer to the router’s operation manual for switching on.

2Connect the ETHERNET terminal on the TV to the router (commercially available) with an ETHERNET cable (commercially available).

3Go to “Network setup” > “Auto setup”, and then press ;.

4Press a/bto select “Wired”, and then press

5Confirm the message on the screen and then press ;to go to the next step.

6Perform “Connection test” after the connection is completed. Press c/dto select “Yes”, and then press ;.

7The connection test result will be displayed on the screen. Follow the on-screen instructions for the settings after this step.

•If you want to change the IP settings manually, go to “Network setup” > “Manual setup” > “IP setup” and follow the on-screen instructions and the operation manual of the router.