Sharp LC-70LE747KN, LC-90LE757RU, LC-70LE747EN Wireless connection overview, Wireless installation

Network setup

Wireless installation	E How to connect		NOTE
			• When not using “Push button”, perform the settings
Use the wireless LAN USB adapter supplied with the			from “Network setup” > “Manual setup” > “Connection
			type”.
TV.
			• To connect your TV to the internet, you must have a
E Wireless connection overview
			broadband internet connection.
			• If you do not have a broadband internet connection,
			consult the store where you purchased your TV or ask
			your internet service provider or telephone company.
			• There is no need to enter the security key for
			subsequent connections to the wireless network.
			• If your access point is set to a stealth mode (that
			prevents detection by other devices), you may not be
	1		able to establish a connection. In this case, disable the
		Switch on your router before starting the	stealth mode on the access point.
 PC		network installation.	• If you want to change the IP settings manually, go to
	2	Connect the wireless LAN USB adapter	“Network setup” > “Manual setup” > “IP setup” and
 Wireless LAN router/access point			follow the on-screen instructions and the operation
		(supplied) to the USB 3 (WIRELESS LAN) port on
 Wireless LAN USB adapter (supplied)			manual of the router.
		the rear of the TV.	• See page 85 to check the supplied SHARP wireless LAN
 Network
		• Do not use a wireless LAN adapter other than	adapter specifications.
NOTE		the supplied SHARP wireless LAN adapter, as
		operations cannot be guaranteed.
• When using the SHARP wireless LAN USB adapter
	3	Go to “Network setup” > “Auto setup”, and then
(supplied), try to provide as much free space around the
device for best performance.		press ;.
• Make sure the firewalls in your network allows access to		NOTE
the TV wireless connection.		• Follow the on-screen instructions when setting
• Operations cannot be guaranteed when used with
		manually.
access points that do not have Wi-Fi® certification.
		Go to “Network setup” > “Manual setup”.
• A wireless LAN access point is required to connect
	4 Press a/bto select “Wireless”, and then press
the TV to the Internet using a wireless LAN. See the
		;.
operation manual of your access point for setup.

5Confirm the WPS location and then press ;to go to the next step.

6Perform “Connection test” after the connection is completed. Press c/dto select “Yes”, and then press ;.

7The connection test result will be displayed on the screen. Follow the on-screen instructions for the settings after this step.

65