Parental rating, Input skip, Input label

Setup menu (Continued)

Parental rating

This function allows TV channels to be restricted. It prevents children from watching violent or sexual scenes that may be considered inappropriate.

1	Repeat steps 1 to 3 in Setting a password.
2	Press a/b to select “Parental rating”, and
	then press ENTER.
3	Press a/b to select your desired rating, and
	then press ENTER.

When the country setting is set to “Australia”.

Selected item	Description

General and	Content is not offensive to most viewers.
above (G)

Parental	Content is such that parents may not want
guidance and	their children to view the programme.
above (PG)

Mature and	Mature audience only. This programme is
above (M)	speciﬁ cally designed to be viewed by adults
	and therefore may be unsuitable for children
	under 15.

Mature adult	Mature adult only. Mature audience only.
and above	This programme is speciﬁ cally designed to
(MA)	be viewed by adults and therefore may be
	unsuitable for children under 15.

Adult violence	Not for children under age 15. Strong
and above	elements of sex and/or violence.
(AV)

Restricted	Not for children under age 18. Strong
and above (R)	elements of sex and/or violence.

No block (–)	Cancel the blocking.

When the country setting is set to “New Zealand” or “Singapore”.

Block 5 age and below

Block 11 age and below

Block 13 age and below

Block 15 age and below

Block 17 age and below

Block 18 age and below

No block

H Input skip

This setting allows you to skip the HDMI or RGB input on the input source selection operation.

INPUT1(HDMI)	Skip input selection of HDMI

INPUT2(HDMI)

INPUT3(HDMI)

INPUT7(RGB)

YesNo

H Input label

You can assign each input source a label as you prefer.

1	Press TV/VIDEO to select the desired input
	source.
2	Press MENU and the MENU screen displays.
3	Press c/d to select “Setup”.
4	Press a/b to select “Input label”, and then
	press ENTER.
5	Press a/b/c/d to select a desired
	alphanumeric, and then press ENTER.
	Repeat until the name is fully spelt out.
	Maximum 6 alphanumeric can be input.



	External equipment name settings





		A	B C D E F G H I J CLEAR
		KLMNOPQRST BACK
		U V W X Y Z + – . _
	0 1 2 3 4 5 6 7 8 9			END

To exit, select END and then press ENTER. If the wrong alphanumeric is entered, select CLEAR to clear, and then press ENTER.

NOTE

•You cannot change labels if the input source is ATV and DTV.

HPosition

For adjusting a picture’s horizontal and vertical position.

Selected item	Description

H-Position	Centres the image by moving it to the left
	or right.
V-Position	Centres the image by moving it up or
	down.
Reset	Reset position to factory preset values.

H HDMI auto view (HDMI input mode only)

Selected item	Description

Enable/	Set whether or not to use WIDE MODE
Disable	based on signal recognition, including an
	HDMI signal.

HWSS

WSS allows a television to switch automatically among the different screen formats. (On, Off)

NOTE

•Try to set WIDE mode if an image does not switch to the correct screen format. When the broadcast signal contains no WSS information, the function will not work even if enabled.

•Not available for COMPONENT, PC and HDMI signal.