Watching TV
Turning On/Off the Power
POWER
INPUT
1 2 3
POWER
Press POWER on the TV, or POWER on the remote control unit to turn the power on.
• POWER indicator: Power on, Green; Power off, red.
Press POWER on the TV, or POWER on the remote control unit again to turn the power off.
•The TV enters standby and the image on the screen disappears.
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the AC outlet.
•Small amount of electric power is still consumed even when the TV is turned off.
•If there is no signal input for 15 minutes, the power will turn to standby mode automatically.
EZ Setup
When you turn on the TV for the first time, the Initial Setup will guide you through the setup process. Perform the following steps before you press POWER on the remote control unit.
1.Insert the batteries into the remote control unit. (See page 12.)
2.Connect the antenna cable to the TV. (See page 11.)
3.Plug in the AC cord to the AC outlet. (See page 9.)
TV USB PC MENU
ENTER
EXITRETURN
1.Initial Setup
•The Initial Setup screen display at the first use. Press ENTER to start the EZ setup.
TV EZ Setup | Welcome |
Thank You for Your Purchase of our SHARP Liquid Crystal Television
Please press [Enter] to start the Wizard.
Enter Enter
2.Language setting
•Select the OSD menu language from English, Spanish, or French.
•Press 
/
to select the desired language listed on the screen, and then press the 
to the next step.
TV | EZ Setup |
| Language |
| Set the | Language | |
|
|
| |
|
| English |
|
|
| Français |
|
|
| Español |
|
Select | Enter Enter | Return Back EXIT Exit |
|
|
|
|
|
TV Location
Select "Home" or "Store" for the location where you plan to install the TV.
3.Location setting
•Press 
/
to select “Home” or “Store” and press 
to the next step.
TV | EZ Setup | TV Location |
| Select where the TV will be placed. | |
| The picture will be optimized for | |
|
| that location. |
|
| Home |
|
| Store |
Select | Enter Enter | Return Back EXIT Exit |
|
|
|
21