Sharp LC-46PX5X Attaching the stand, Preparation, Confi rm the 10 screws supplied with the TV

Preparation

Attaching the stand

•Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Attach the stand in the correct direction.

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

1Confi rm the 10 screws supplied with the TV.

Short screws (g6)	Long screws (g4)
(used in step 2)	(used in step 3)

2Attach the two supporting post for the stand unit onto the base using the box for the stand unit as shown below.

(Close-up of the upper side of the stand unit)

31 Insert the stand into the openings on the bottom of the TV.

2Insert and tighten the 4 long screws into the 4 holes on the rear of the TV.

	Hex key
2	Long screw 2
	Soft cushion

23

	1
3	Hex key
	2
1

Short screw

1Insert each of the protrusions on the two supporting posts into the openings on the upper side of the base.

2Insert and tighten the 6 short screws with the hex key (supplied with the product) in the order of 1, 2 and 3.

1

NOTE

• To detach the stand, perform the steps in reverse order.

6

PX5X_EN.indb 6

2007-5-9 11:43:14