Sharp LC-32LE144E, LC-32LE244E operation manual Manual tuning

Press to select Start Scan, and press OK to start auto tuning.

Channel Setting

NOTE

Auto Tuning• You may be prompted to select your local cable operator before running the cable scan mode.

Auto Tuning

The TV automatically detects and stores all available services in your area. This function also allows you to perform the channel setting for digital and analogue individually and reconfigure the settings after the initial auto installation has been completed.

Press MENU.

Press	to select Setup, and press OK.
Press	to select Auto Tuning, and press OK.

ETuner Mode - Antenna

1. Press to select ATV and DTV, DTV or ATV, and press OK.

Auto Tuning

Previous settings will be lost !

Press EXIT for no change.

Tuning Mode		ATV and DTV
Start Scan		OK
OK Enter	RETURN Back

2.When country was selected “Others” and ATV

system was selected, press		to select
System, and press	to select system.

3.

4.If you are able to receive broadcasts from more than one region or transmitter you will be prompted to choose via an OSD menu.

ETuner Mode - Cable

1. Press to select ATV and DTV, DTV or ATV,

and press OK.

3.	Press	to select Scan type, and press
	to select Quick Scan or Full Scan.
4.	Press	to select Start Frequency, End

Frequency, Modulation, Symbol Rate or Network ID, and use digit buttons on the remote control to define the information or select Auto for tuning.

5.When country was selected “Others” and ATV

system was selected, press			to select
System, and press		to select System.
6. Press	to select Start Scan, and press OK to

start auto tuning.

NOTE

•The information should be given by your cable provider.

•Network ID is only available for Quick Scan.

Manual tuning

There are two TV modes: ATV and DTV that can be tuned-in manually using Manual Tuning.

ATV Manual Tuning

Press MENU.

Press	to select Setup, and press OK.
Press	to select ATV Manual Tuning, and press
OK.

EChannel Sort

Channel Sort allows you to reorder the channels.

1. Press		to select desired channel and press .
		ATV Manual Tuning
	Position	Channel	Station
	1	C1	ííííí
	2	C2	ííííí
	3	C3	ííííí
	4	C4	ííííí
	5	C5	ííííí
	6	C6	ííííí

Auto Tuning

Previous settings will be lost ! Press EXIT for no change.

Tuning Mode

Start Scan

Operator Selection

Scan Type

Start Frequency (MHz)

End Frequency

Modulation

Symbol Rate

Network ID

ATV and DTV

OK

Quick Scan

Auto

Auto

Auto

Auto

Auto

Sort	OK Enter	RETURN Back
2. Press	to select the channel you wish to
swap and press .

The positions of the two channels are swapped.

	Edit	RETURN Back
2. Press	to select Operator Selection, and
press	to select Operator Selection.

12 -

SHARP_LE144E_Rev1_GB_English.indd 12 2012/09/13 17:43:59