Inserting Batteries Remote Control Handset

Inserting Batteries in the

Remote Control Handset

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

•Connect the power cord to the 220-240V AC, 50 Hz.

•Press STANDBY switch. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, P+ / P- or a numeric button on the remote control.

•Press the -P/CHor P/CH+ button on the TV. The TV will then switch on.

Note: If you switch on your TV via PROGRAMME UP/DOWN buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV Off

•Press the “” button on the remote control or press the STANDBY switch, so the TV will switch to standby mode.

•To power down the TV completely, unplug the power cord from the mains socket.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

Input Selection

Once you have connected external systems to your TV, you can switch to different input sources.

•Press “SOURCE” button on your remote control for directly changing sources.

or,

•Select “Source” option from the main menu by using “” or “” button. Use then “” or “” button to highlight an input and press “” button to select.

Note: You can mark desired source options by

pressing the OK button. Therefore, when “SOURCE” button is pressed, only the marked source options will be available (except for the TV source).

Basic Operations

You can operate your TV using both the remote control and onset buttons.

Operation with the Buttons on the TV Volume Setting

•Press “” button to decrease volume or “

”button to increase volume, so a volume level scale (slider) will be displayed on the screen.

Programme Selection

•Press “P/CH +” button to select the next programme or “P/CH -” button to select the previous programme.

Viewing Main Menu

•Press “” / “” buttons at the same time to view main menu. In the Main menu select sub- menu using “P/CH -” or “P/CH +” buttons and enter

the sub-menu using “” or “” buttons. To learn the usage of the menus, refer to the menu system sections.

AV Mode

•Press the “TV/AV” button in the control panel on the TV to switch between AV modes.

English - 11 -

[GB]_MB35_COST_46882W-1810UK_PANEUIDTV_SILVER1_TECHNIKA_10065830.indd 11

16.10.2009 10:21:29