Operation with the Remote Control
•The remote control of your TV is designed to control all the functions of the model you selected. The functions will be described in accordance with the menu system of your TV.
•Functions of the menu system are described in the following sections.
Volume Setting
•Press “V +” button to increase the volume. Press “V
Programme Selection (Previous or Next Programme)
•Press “P
•Press “P +” button to select the next programme.
Programme Selection (Direct Access)
•Press numeric buttons on the remote control to select programmes between 0 and 9. The TV will switch to the selected programme. To select programmes between 10 - 299 (for IDTV) or
•Press directly the programme number to reselect single digit programmes.
Initial Settings
When the TV is turned on for the first time, the menu for the language selection appears on the screen. The message “Welcome please select your language!” is displayed in all language options sequentially in the OSD.
By pressing the “
” or “
” buttons highlight the language you want to set and press OK button. After then, “First time installation” OSD will appear on the screen.
By pressing “
” or “
” buttons, select the country you want to set and press OK button. button (** for EU countries).
Note: Country selection OSD will not be available for UK.
After then, the active antenna selection OSD appears on the screen:
By pressing “
” or “
” buttons, set active antenna mode as on or off.
If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Configuration Menu in the following sections for more information.
Press OK button on the remote control to continue and the following message will be displayed on the screen:
•To select the “Yes” or “No” option, highlight the item by using “
” or “
” buttons and press the OK button.
The IDTV will automatically tune to the UHF or VHF (** for EU countries) transmission channels, searching for digital terrestrial TV broadcasts and displaying the names of channels found. This process will take about a few minutes. To cancel searching, you can press the “M” button at any time during the process.
After Automatic Search is completed, the following message asking for analogue channel search appears on the screen:
To search for analogue channels, select “Yes”. TV switches to the analogue TV mode. The menu below is displayed to search for analogue channels:
English - 12 -
16.10.2009 10:21:30 |