Sears SRCD227, SRCD223 owner manual Installing the Batteries, Connections to Front A/V Jacks

TO RECORD A SCRAMBLED/UNSCRAM- BLED CHANNEL

1.Set the TV/DVD/VHS channel selector to the out- put channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to record from your Cable Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV sys- tem installer’s attention to Article 820-40 of the NEC that provides guidelines for proper ground- ing and, in particular, specifies that the cable ground shall be connected to the grounding sys- tem of the building as close to the point of cable entry as practical.

INSTALLING THE BATTERIES

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 “AA” penlight batteries into the battery

compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

CONNECTIONS TO FRONT A/V

JACKS

When you watch a program recorded on an another source (VCR or video camera), use the audio/video input jacks on the front of the TV/DVD/VHS.

Connect the audio/video output jacks of another source to the AUDIO L/R and VIDEO jacks of this TV/DVD/VHS.

Then press the CHANNEL K/L buttons until "AUX" appears on the screen.

You may access the front A/V Input directly by pressing the numbers 00 on the remote control. See page 9.

NOTE:

•When you connect a monaural VCR (another source) to this TV/DVD/VHS, connect the Audio output jack of the monaural VCR (another source) to the AUDIO L jack of this TV/DVD/VHS. The audio will output in both L and R channel equally.

[Another source]

etc.

To the video output jack

To the audio output jacks

HEADPHONE VIDEO L-AUDIO-R

Audio/Video coaxial cable (not supplied)

[Front of the TV/DVD/VHS]

[Fig. 5]

- 12 - EN

1C29