WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE.
| CAUTION |
| THIS SYMBOL INDICATES THAT DAN- | ||
|
|
|
| GEROUS VOLTAGE CONSTITUTING A | |
| RISK OF ELECTRIC SHOCK |
| |||
|
|
| RISK OF ELECTRIC SHOCK IS PRE- | ||
| DO NOT OPEN |
|
| ||
|
|
|
| SENT WITHIN THIS UNIT. | |
CAUTION: TO REDUCE THE RISK OF ELECTRIC | |||||
|
| ||||
| THIS SYMBOL INDICATES THAT | ||||
SHOCK, DO NOT REMOVE COVER (OR BACK) NO |
| ||||
| THERE ARE IMPORTANT OPERATING | ||||
USER SERVICEABLE PARTS INSIDE. REFER SER- |
| ||||
| AND MAINTENANCE INSTRUCTIONS | ||||
VICING TO QUALIFIED SERVICE PERSONNEL. |
| ||||
| IN THE LITERATURE ACCOMPANYING | ||||
|
|
|
| ||
|
|
|
| THE APPLIANCE. | |
|
|
|
|
|
The important note is located on the rear of the cabinet.
IMPORTANT SAFEGUARDS
FIGURE A
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
| ANTENNA |
| LEAD IN |
| WIRE |
| GROUND |
| CLAMP |
| ANTENNA |
| DISCHARGE UNIT |
| (NEC SECTION |
ELECTRIC |
|
SERVICE |
|
EQUIPMENT |
|
| GROUNDING CONDUCTORS |
| (NEC SECTION |
| GROUND CLAMPS |
NEC - NATIONAL ELECTRICAL CODE | POWER SERVICE GROUNDING |
| ELECTRODE SYSTEM |
S 2 8 9 8 A | (NEC ART 250, PART H) |
AMEUBLES- Cet appareil ne doit être placé que sur un meuble (avec ou sans roulettes) recommandé par le fabricant. Si vous l’installez sur
un meuble à roulettes, déplacez les deux ensembles avec précau- tion. Un arrêt brusque, l’utilisation
d’une force excessive et des sur- faces irrégulières risquent de déstabiliser l’ensemble et de le
renverser.
9.
10. Power
11. Grounding or
12.
13.Outdoor Antenna
14.
15.Power
16.
17.Object and Liquid
18.
19.Damage Requiring
sonnel under the following conditions:
a. When the power supply cord or plug is damaged or frayed.
b. If liquid has been spilled, or objects have fallen into the TV.
c. If the TV has been exposed to rain or water.
d. If the TV does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified techni- cian to restore the TV to its normal operation.
e. If the TV has been dropped or damaged in any way. f. When the TV exhibits a distinct change in perfor-
20.Replacement
21.Safety
22.
- REAR PANEL -
VIDEO | L AUDIO R |
MENU | VOLUNE | CHANNEL | POWER |
VIDEO 2
ANT. IN
R | L | VIDEO |
VIDEO01 – INPUT
1 2
- REMOTE CONTROL -
3 | 4 | 5 | 6 | 7 |
16 | 2 | 1 | 15 |
|
|
|
| 14 |
6 | POWER |
| GAME | SLEEP |
|
|
| 13 | |
|
|
|
| DISPLAY |
| 1 | 2 | 3 | 12 |
8 | 4 | 5 | 6 | CHANNEL |
|
|
| ||
|
|
| RETURN | |
| 7 | 8 | 9 | 11 |
|
| 0 | +100 | INPUT |
|
|
|
| |
|
|
|
| SELECT |
|
|
|
| 10 |
5 |
|
| CH |
|
|
|
|
| |
4 |
| VOL |
| VOL |
|
| CH |
|
MUTE | 9 |
|
MENU
3
1.VIDEO (in) jack- Connect to the video output jack of a video camera/game, satel- lite, DVD or VCR.
2.AUDIO L/R IN jacks- Connect to the left/right channel audio output jacks of a video camera/game, satellite, DVD or VCR. NOTE: The AUDIO L (IN) jack is for mono input. The sound is heard from both speakers. Use this jack for monaural audio equipment to be hooked up.
3.MENU button- Press to display the menu on the TV screen.
4.VOLUME ▲/▼ buttons- Press to control the volume level.
Press to determine the setting mode from the menu on the TV screen. (only the VOL ▲ button)
Press to select or adjust from a particular menu. (for example: Language Selection, Channel Presetting, Closed Caption Selection, Picture Adjustment,
5.CHANNEL ▲/▼ buttons- Press to select memorized channel.
NOTE:You MUST PRESET channels BEFORE using CHANNEL ▲/▼ button. (See CHANNEL PRESETTING.)
Press to select the setting mode from the menu on the TV screen.
Press to select item you want to adjust in the picture control mode.
6.POWER button- Press to turn the TV ON and OFF.
7.Infrared Sensor Window- Receives the infrared control signals from the remote control unit.
8.CHANNEL NUMBER button- Press two digits to directly access the desired channel. Remember to press a "0" before a single digit channel.
+100 button- Press to select cable channels higher than 99.
9.MUTE button- Press the MUTE button to turn off the sound portion of the TV pro- gram. (Volume level display turns LIGHT RED from LIGHT BLUE.) Press the MUTE button again or press the VOL(ume) ▲ or ▼ button to restore sound.
10.INPUT SELECT button- Press to select TV or the external input (VIDEO1 or VIDEO2) mode.
(See USING AUDIO/VIDEO INPUT JACKS.)
11.CHANNEL RETURN button- Press this button to go back to the previously viewed channel. For example, pressing the CHAN- NEL RETURN button once will change channel display from CH 3 (present chan- nel) to CH 10 (previously viewed channel), and pressing it a second time will return from CH 10 to CH 3.
12.DISPLAY button- Press to display the channel number on the screen. If you press it again, the channel number will disappear.
13.SLEEP button- Press the SLEEP button to display the sleep timer and start the func- tion. The shut off time can be determined by the number of times you press the but- ton. (0, 10, 20, 30,..90, 0 minutes)
14.GAME button- Press to set the Game mode and external input mode at the same time. To exit, press the INPUT SELECT button.
(See USING AUDIO/VIDEO INPUT JACKS and PICTURE ADJUSTMENT.)
15.ANT(enna). IN jack- Connect to an anten- na, cable system, or satellite system.
16.AC cord- Connect to a standard AC outlet (120V/60Hz).
NOTE: Unwrap the AC cord completely from the backcover before plugging the cord into an AC outlet.
INSTALLING THE BATTERIES
1)Slide the battery compartment cover back on the remote unit.
2)Insert 2 "AA" penlight batteries into battery compartment in the direction as indicated by the polarity (+ /
3)Replace the cover.
USING AUDIO/VIDEO INPUT JACKS
When you use the AUDIO/VIDEO input jacks, select “VIDEO1” or “VIDEO2” mode by pressing the INPUT SELECT button on the remote control.
•To use the jacks on the back of the TV, select “VIDEO1”.
•To use the jacks on the front of the TV, select
“VIDEO2”.
NOTES:
•You may also select Game mode and Video2 at the same time by pressing the GAME but- ton on the remote control. "GAME" appears on the TV screen. The TV will switch to Video2 input on the front of the TV. (See
PICTURE ADJUSTMENT.)