Sansui SLED1928 owner manual How to attach the stand, How to remove the stand

How to attach the stand

NOTE:

•Unplug the AC cord from the AC INPUT terminal.

•Before beginning this process, assure that the TV is laid on a clean, safe, and cushioned surface to avoid any damage to the unit.

•Do not touch or press the TV-screen, glass might break under pressure.

Place the TV on its front onto a table.

Align the stand’s bottom-plate (supplied) as seen here.

It will fit in only one direction.

Hold the unit and attach the stand slowly, as shown in Figure 1.

LCD PANEL SIDE

Figure 1

Figure 2

Finally secure the bottom-plate with 2 screws (supplied) as indicated by the arrows in Figure 2.

• Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support your unit correctly, and could result in damage or injury from tip-over.

How to remove the stand

When you transport this product, remove the stand and pack flat against the back of the unit in the carton. To remove the stand, perform these steps in reverse order.

For wall mounting, the base must be removed. To disconnect the base/stand remove the three (3) screws from the back (see page 5).

6