Remote control |
|
|
|
|
Inserting Batteries |
|
|
|
|
1 Open the battery compartment | ,I | Install | two "AAA" | batteries, |
cover in the direction of the arrow, |
| paying | attention | to the |
polarity diagram in the battery compartment.
(continued)
Replace the compartment cover.
Operation
•Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within a 30 | ° angle on either side of | 15 feet | ||
the remote sensor, up to a distance of | approximately | 15 feet. | ||
| ||||
NOTE:
•Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
•The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote sensor may shorten operating distance.
•Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.
•Do not mix old and new batteries.
•Remove batteries if the remote control will not be operated for an extended period of time.
Power source
TO USE AC POWER
1.Connect the AC cord plug into this unit's AC IN jack.
2.Connect the AC cord into an AC outlet.
AC Outtet
Wider Hole
and_I
120V, 60Hz
AC cord (supplied)
NOTE:
•Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.
•The AC Cord has a
WARNING:
•DO NOT CONNECTTHIS UNITTO THE POWER USING ANY DEVICE OTHERTHAN THE SUPPLIED AC CORD.THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.
•DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE DISPLAYED. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.
CAUTION:
•WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF SAFETY, BE SURE TO UNPLUG IT FROM THE AC OUTLET.
•DO NOT PLUG/UNPLUG THE PLUG WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL SHOCK.
•IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS
RECOMMENDED. CONTACT CUSTOMER SERVICE AT