Securing the Flat Panel to the Wall Mount

SFM1

Securing the Flat Panel to the Wall Mount

WARNING: At least (2) qualified personnel are strongly recommended for installation of this product. Failure to do so could result in serious injury and possible damage to the flat panel.

1.Raise the flat panel with the LEFT and RIGHT mounting brackets secured to the flat panel and insert the top hooks from each bracket to the rod on the wall plate (Figure 15).

Wall Plate

TOP

BOTTOM

Figure 15. Securing the Flat Panel

Lateral Shift Adjustment

1.Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on the bottom of the mounting brackets (Figure 16).

2.Use the foot leveler to adjust your plasma.

CAUTION: Do not over tighten the ¼”-20 screws to the rods.

Lateral Shift

Figure 16. Lateral Shift Adjustment

Page 14

Sony SFM1 installation manual Securing the Flat Panel to the Wall Mount, Lateral Shift Adjustment