SFM1
Griplates™
1.The Griplates™ have M4, M5, M6 and M8 hole patterns to fit the hardware that the flat panel requires. Examples: If your display uses M8 x 20 Phillips head screws. Use the M8 mounting points (Figure 7).
Dimples | M8 |
|
|
M6
M5
M4
Figure 7. Griplates™ Orientation
2.Once the mounting brackets are aligned, secure the Griplate™ to the flat panel.
NOTE: The dimples of the top plates have to be facing up and the bottom dimples must be facing down. Use (1) Griplate™ per mounting point (Figure 8).
NOTE: Leave a ¾” gap on both mounting brackets as shown on this diagram.
CAUTION: Do not over tighten the mounting hardware.
Phillips Screw Driver
DIMPLES
| FACING UP |
|
DIMPLES |
|
|
FACING UP | DIMPLES |
|
|
| |
| FACING DOWN | Bottom Flat Panel |
DIMPLES
FACING DOWN
3/4"
Figure 8. Griplate™ Attachment
Installation Manual | Page 9 |