SFM1
Flat Panel Mount Location
WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
1.Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring from outside to outside of the chassis (Figure 1).
2.Using a pencil lightly mark the center of your flat panel (Figure 2).
Top of Flat Panel
Inverted Flat | Inverted Flat | |
Panel | ||
Panel | ||
|
| C |
| C |
Measuring Tape | L | Mark the Center | L |
Bottom of Flat |
| ||
| Panel | of the Flat Panel |
|
Figure 1. Flat Panel Mount Location | Figure 2. Marking the Mount |
| |
Mounting Bracket Positioning
1.Install the nylon spacers to the mounting points on the flat panel (Figure 3)
2.Lay the left and right mounting brackets (stamped arrows facing out) (Figure 4).
Page 6 | Installation Manual |