7 - Advanced operations
Time display switching
During audio CD playback (or playback standby), when the DISPLAY key on either the front panel or the remote control is pressed, the time display will switch through several modes in the following order.
Elapsed track time (no display light indication) Remaining track time (REMAIN is lit in the display) Remaining disc time (T. and REMAIN are lit in the display)
When stopped, the total recording time is shown, regard- less of the status of the TOTAL and REMAIN indicators.
When playing an MP3 disc, elapsed track time is always displayed, and the DISPLAY key does not operate. Even when the power is turned off, the time display mode setting is retained.
When in program play mode, remaining total program time (when T.REMAIN is lit) and total program time (when stopped) are shown.
End of track warning (EOM)
When nearing the end of a track, a warning indication is shown on the display.
The number of seconds before the track end that the warning is displayed can be set beforehand, so that when playback reaches that point, the two colons will begin flashing on the display.
To set the warning display time, use the EOM menu (menu number 10 EOM).
EOM time can be set from OFF, 5, 10, 15, 20, 25, 30 (default), and 35.
This function is not supported for MP3 playback.
Eject block
When eject block is on, the EJECT key cannot be used when a disc is being played back or paused.
Use the eject block menu (menu number 02 BLOCK) to turn this function on and off.
Fader start/Event start
Fader start/stop
Connect the RELAY IN jack (mini jack) on the rear panel and fader start terminal on the external device which supports the fader start function.
SLEEVE
STOP |
| RELAY IN |
|
| |
START |
|
|
TIP | SLEEVE | TIP |
For
STOP | CONTROL I/O |
| PIN8 GND |
START | PIN11 |
| FADER STRAT/STOP |
The relay play menu (menu number 06 RELAY) should be set to FDR.
See more detailes for the CONTROL I/O terminal in the secsion External parallel control on page 24.
TASCAM
