Tascam CD-01 U Restoring factory default settings, External parallel control, Event start

7 - Advanced operations

Event start

Connect the RELAY IN jack (mini jack) on the rear panel and event start terminal on the external device which supports the event start function.

The relay play menu (menu number 06 RELAY) should

be set to ON.

Restoring factory default settings

To restore all settings to their factory defaults:

1 Select the factory preset menu (menu number 14 F- PRE).

2 The display shows 14 flashing, then press the PITCH knob on the front panel or ENTER key on the remote control to confirm the selection.

3 The display shows - SURE - flashing to recomfirm that this operation is surely desired.

4 Press the PITCH knob on the front panel or ENTER key on the remote control to restore all settings to their default values.

The following settings are restored to default values.

≠Playback mode

≠Time display mode

≠Auto ready

≠Auto cue

≠Pitch control value

≠All menu settings

You can cancel to restore the default settings either the

stage 14 F-PRE or SURE is flashing by pressing the

other keys except the SHIFT key and the PITCH knob

on the front panel.

External parallel control

The CD-01U Pro can be controlled from an external

devices which supports a parallel interface via the CON-

TROL I/O terminal on the rear panel.

REMOTE(PARALLEL)

81

159

Pin No.	Description	In/Out
1	Stop tally	Out
2	Skip (Back)	In
3	Skip (Forward)	In
4	No Disc tally	Out
5	EOM tally	Out
6	Search (Back)	In
7	Search (Forward)	In
8	GND
9	Play tally	Out
10	Pause tally	Out
11	Fader start/stop	In
12	Stop	In
13	Play	In
14	Pause	In
15	+5V

In:

Input signals are active when low (ground) for > 30 ms.

Out:

Tally signals are open collector, with a maximum current of 50 mA.

+5V:

The maximum current supplied from this terminal is 50 mA.

24 TASCAM CD-01U/CD-01UPro