4 - Features and their functions

Rear panel

1ANALOG OUTPUT terminals

The analog line output terminals are for RCA pin jacks. The maximum output level is +6 dBV.

2DIGITAL (OPTICAL) OUTPUT terminal

Provides the digital audio signal in S/PDIF format. This connector outputs the 44.1KHz digital signals constantly even if pitch control is activated.

3CONTROL I/O (RS-232C) connector

This RS-232C interface allows control by a computer or by other serial controllers. Consult your TASCAM dealer the TASCAM web site for details of this port if you wish to use it.

4RELAY IN/OUT jacks

These jacks are used to perform the relay play operation between two or more CD-01U/CD-01U Pro, or perform the fader start or event start operation.

5ANALOG OUTPUT (BALANCED) terminals (CD- 01U Pro only)

The analog line output terminals are for XLR connectors. The maximum output level is +20 dBu.

6DIGITAL (AES/EBU) OUTPUT terminal (CD-01U Pro only)

Provides the digital audio signal in AES/EBU format. This connector outputs the 44.1KHz digital signals constantly even if both control is activated.

7CONTROL I/O (PARALLEL) connector (CD-01U Pro only)

Parallel control from an external devices can be performed.

8 IN

Connect the power cable supplied with the CD- 01U/CD-01U Pro.

Remote Control Unit

1 EJECT BLOCK key

This turns the Eject Block mode on and off.

2 DISPLAY key

Pressing this key changes the time mode on the display.

3 PLAY MODE key

This selects the playback mode. During selection, the playback mode is indicated on the display in the following manner.

Normal playback (in disc order): no indication

Single playback: S lights up

Program playback: PGM lights up

Random playback: RANDOM lights up

4 EJECT key

Press this to eject the disc. This key cannot be used when Eject Block mode is on and the disc is being played back.

12 TASCAM CD-01U/CD-01UPro

Page 12
Image 12
Tascam CD-01 U, CD-01UPro owner manual Rear panel, Remote Control Unit