| CD / |
|
|
English | Disc Change |
You can change the outer two discs while | |
| the third inner disc is stopped or is playing. |
1Press DISC CHANGE.
™ The disc carousel tray slides out.
2Replace the discs in the left and right disc trays.
•If you press DISC CHANGE again
during playback, the disc will stop playing.
™The disc carousel tray will rotate until the inner tray is rotated out and is ready for changing.
3Press OPEN•CLOSE to close the disc carousel tray.
Selecting a desired track
Selecting a desired track when playback is stopped
•Press digit 0 – 9 on the remote control to select the desired track.
™Playback will start immediately for the selected track.
™The selected track number and elapsed playing time appear on the display.
14
Selecting a desired track during playback
•Press íor ë(or digit
™The selected track number and elapsed playing time appear on the display.
•If you press íonce it will skip to the beginning of the previous track and play the track.
For
1Press ALBUM
2Press TITLE
™The selected track number and elapsed playing time appear on the display.
3Press PLAYÉÅ to start playback.
Searching for a particular passage during playback
•Press àor áuntil the desired passage is located.
™ The volume will be reduced.
•Press PLAYÉÅ to resume normal playback.
Programming Tracks
Programming tracks of a loaded disc is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 99 tracks can be stored in the memory in any order. When 99 tracks are stored and you attempt to store another track, the display will show “FULL”.
1Load the desired discs in the disc trays.
2Press the CD (CD 1•2•3) button to select the disc tray.
™Programming can only be done on the selected disc.
3Press PROG to start programming.
™The PROGRAM starts flashing.
™It will cancel any previously programmed tracks and selected repeat mode.
4Pressíor ë(or digit 0-9 on the
remote control) to select the desired track.
•For
programming.
5Press PROG to store the track.
• Repeat steps 4 to 5 to store other tracks.
6Press Çonce to end programming.
™The total number of tracks programmed and total playing time appear on the display.
Notes:
–For MP3-CD, total playing time will not be shown.
–If the total playing time is more than
“99:59” then
–If the system is reading the disc, programming is not possible, “READING DISC” will be displayed.
–During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically.
Reviewing the program
Reviewing of program is possible only when playback is stopped.
1Press íor ë repeatedly to review the programmed tracks.
2Press Çto exit review mode.
14 | 12/8/00, 1:57 PM | 3139 115 20071 |