Sanyo MCD-ZX540F CD Play, Temporarily stopping play, Skip play, Search forward/reverse

Page 5

CD PLAY

Use compact discs bearing the symbol shown below. In addition to conventional 12cm CDs, this system can be used to play 8cm CDs without an adapter.

1.Set the FUNCTION switch to CD. “--” blinks for several seconds then the CD mode ap- pears.

2.Press the CD compartment lid (OPEN/ CLOSE portion) to open it. “00” appears on the dis- play.

3.Place the disc with the label facing up on the turntable as shown below. (Place only one disc at a time.)

4.Press the CD compartment lid (OPEN/ CLOSE portion) to close it.

The total number of tracks on the disc appears on the display.

5.Press the PLAY/PAUSE i button.

The current track number appears. Play starts from the first track.

-To start play from the desired track, select the track by using the f or e button, then press the PLAY/PAUSE i button.

Note:

If no disc is loaded or the disc is located with the label facing down “00” appears. If these occur, load the disc correctly or replace the damaged disc.

6.Press the STOP n button to end disc play back.

When the last track has been played, the player stops automatically.

7.To turn the CD player off, set the FUNCTION switch to TAPE/OFF .

Note:

Do not open the CD compartment during CD play. Always press the STOP n button and wait for the disc to stop rotating before opening the CD compartment.

This unit can play back the CD-R/RW as well. However, some CD-R/RW can not be played back depending on the recording conditions.

Notes on handling compact discs

-Do not expose the disc to direct sunlight, high humidity or high temperature for ex- tended periods of time.

-Discs should be returned to their cases after use.

-Do not apply paper or write anything on the disc surface.

-Handle the disc by its edge. Do not touch the playing surface (glossy side).

-Fingerprints and dust should be carefully wiped off the playing surface of the disc with a soft cloth.

Wipe in a straight motion from the center to the outside of the disc.

-Never use chemicals such as record clean- ing sprays, antistatic sprays or fluids, ben- zene or thinner to clean compact discs.

Temporarily stopping play

Press the PLAY/PAUSE i button, “a” blinks on the display. To resume play, press the button again.

Skip play

To skip to track 6 while track 3 is playing, press the e button repeatedly until “6” appears on the display. To skip back to track 3 while track 6 is playing, press the f button repeatedly until “3” appears.

Search (forward/reverse)

If the e or f button is pressed during play, the player will search at high speed in the forward or reverse direction while the button is being pressed. When the button is released, normal play will continue.

- 4 -

540AU.indd 4

2009.4.8 10:11:15 AM

Image 5
Contents MCD-ZX540F MCD-ZX541F Precautions 24 23 13 12 11 10 ControlsGeneral Operation Power SupplyInstalling batteries Temporarily stopping play CD PlaySkip play Search forward/reverseChecking the programme Repeat playing modeChanging a programme To add a new track to a programmeListening to Tapes Listening to Other SourcesPause Fast forward and rewindSafeguards against accidental erasure When beat is heardListening to the Radio RecordingCleaning the tape heads MaintenanceCleaning the CD player lens Cleaning the unitCD player General SpecificationsRadio Cassette deck