SET UP FOR USE
TV SECTION
SELECTING THE LANGUAGE
TV
1Plug in the TV/DVD power cord
Plug the TV/DVD power cord into a standard AC outlet.
NOTE:
• If any digits appear in the corner of the screen, press POWER without unplugging the power cord.
Make sure ...
•Press POWER to turn on the TV/DVD.
NOTE: This function effects only the language on the screen menu and not the audio source.
2 Select “LANGUAGE” | - TV SETUP - |
Press SETUP on the remote control. | CHANNEL SET UP |
Press Arrow (K/L) to point to | |
B LANGUAGE [ENGLISH] | |
CAPTION [OFF] | |
“LANGUAGE”. |
|
3Select “ENGLISH”, “ESPAÑOL” or “FRANÇAIS”
Select “ENGLISH”, “ESPAÑOL”= Spanish or “FRANÇAIS”= French using ENTER.
4Exit the Language mode
Press SETUP to return to TV mode.
NOTE: If for some reason the menu is in Spanish or French, press SETUP, press Arrow (K/L) to point to “IDIOMA [ESPAÑOL]” or “LANGAGE [FRANÇAIS]”, then press ENTER, then press SETUP on the remote control.
CHANNEL SET UP
TV
You can program the TVs tuner to program all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.
Make sure ...
•Press POWER to turn on the TV/DVD.
1 Select “CHANNEL SET UP” |
|
Press SETUP on the remote control. | - TV SETUP - |
Press Arrow (K/L) to point to | B CHANNEL SET UP |
“CHANNEL SET UP”. | |
LANGUAGE [ENGLISH] | |
Then, press ENTER. | CAPTION [OFF] |
|
2 Begin auto ch programming |
|
Press Arrow (K/L) to point to | – CHANNEL SET UP – |
“AUTO CH PROGRAMMING”. | ADD / DELETE CH (CATV) |
Then, press ENTER. | B AUTO CH PROGRAMMING |
The tuner scans and memorizes all |
|
the active channels in your area. |
|
3After scanning
The tuner stops on the lowest memorized channel.
•When AUTO CH PROGRAMMING is activated where there is no TV signal input, “NO TV SIG- NALS” will appear on the display after the com- pletion of the channel scanning.
CHANNEL PRESETTING:
•The TV may memorize TV channels as CATV channels if reception conditions are poor. If this happens, check the antenna connections and try the AUTO PRESET CH action again, or wait until reception conditions are better and then try it again.
– 13 – | EN |