
Before you start
Functional overview
Front Panel | 1 |
(*) The unit can also be turned on by pressing these buttons.
1. Disc tray
Place a disc when open.
2. Display
Refer to “Front Panel Display” on page 12. 3. OPEN/CLOSE A button*
Hit to open or close the disc tray. 4. CHANNEL L / K button
Press to change the channel up and down. 5. REV E button
During playback, hit to skip to the previous chapter or track.
During playback, press and hold for 1.5 seconds for fast reverse. When playback is paused, hit repeatedly for slow reverse.
6. FWD D button
During playback, hit to skip to the next chapter or track. During playback, press and hold for 1.5 seconds for fast forward.
When playback is paused, hit repeatedly for slow forward. 7. STOP C button*
Hit to stop playback or recording. 8. PLAY B button*
Hit to start or resume playback.
2 | 3* 4 | 5 6 7* 8* 9 | |||
| OPEN/CLOSE CHANNEL | REV FWD | STOP | PLAY | POWER |
| REC SPEED REC/OTR |
|
|
|
|
|
| VIDEO | L | AUDIO R |
15 | 14 13 | 1211 10 |
9. | POWER button |
|
Hit to turn on and off the unit.
Hit to set the
10. AUDIO input jacks (LINE2)
Use to connect external equipment with standard audio cables.
11. VIDEO input jack (LINE2)
Use to connect external equipment with a standard video cable.
12.
Use to connect the
13. REC/OTR button
Hit once to start a recording. Hit repeatedly to start
a
14. REC SPEED button
Hit to switch the recording speed.
15. Remote control sensor
Receive signals from your remote control so that you can control the unit from a distance.
Rear Panel | 1 2 | 3 | 4 |
VIDEO IN
IN
IN
OUT | L |
| |
| R |
ANTENNA AUDIO IN | |
| (L1) |
COMPONENT
VIDEO OUTPUT
OUT
Y
PB/CB
PR/CR
VIDEO OUT | |
| DIGITAL AUDIO OUTPUT |
L | PCM / BITSTREAM |
R |
|
AUDIO OUT | COAXIAL |
11 10 9 8 7 6 5
1. ANTENNA IN jack Use to connect an antenna.
2. VIDEO IN jack (LINE1)
Use to connect external equipment with a standard video cable.
3. VIDEO OUT jack
Use to connect a TV monitor,AV receiver or other equipment with a standard video cable.
4. AC Power Cord
Connect to a standard AC outlet to supply power to this unit.
5. COAXIAL DIGITAL AUDIO OUTPUT jack Use to connect an AV receiver, Dolby Digital decoder or other equipment with a coaxial digital input jack with a digital coaxial cable.
6. AUDIO OUT jacks
Use to connect a TV monitor,AV receiver or other equipment with standard audio cables.
7. COMPONENT VIDEO OUTPUT jacks
Use to connect a TV monitor with component video inputs with component video cables.
8.
Use to connect the
9.
Use to connect the
10. AUDIO IN jacks (LINE1)
Use to connect external equipment with standard audio cables.
11. ANTENNA OUT jack
Use to connect an antenna cable to pass the signal from the TV ANTENNA IN to your TV monitor.
Note
•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.
•This unit does not have the RF modulator.
8