JVC AV-32S565 manual Set Lock Code, Auto Demo

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre- set with a lock code of “0000”. You may change the code to any four-digit number you wish. To change the lock code, follow the steps below.

Press the MENU button

π† To SET LOCK CODE

è To operate (lock icon appears) Press ZERO to access the lock code

The first digit will be highlighted è To select the number

SET LOCK CODE

LOCK CODE 0000

PRESS OK TO FINISH

SELECT OPERATE MENU EXIT

π† To move to the next digit

Continue to follow these directions for all four numbers

Press the OK button to finish (your lock code is now set) Press the MENU button when finished

When a viewer attempts to watch a blocked channel, this message appears:

The channel will remain blocked until the correct lock code is entered (see above for information on setting your lock code).

THIS PROGRAMMING EXCEEDS YOUR RATING LIMITS.

PLEASE ENTER LOCK CODE BY 10 KEY PAD TO UNLOCK IT.

NO. - - - -

Notes:

•After a power interruption you must reset the lock code.

•Write your lock code number down and keep it hidden from potential viewers.

•If you forget the lock code, a new code may be set using the steps listed above.

Auto Demo

This function lets you preview the many different viewing modes of your TV. It will cycle through “Multi Screen Demo”, “Picture in Picture Demo”, the different “16:9” ratios and all of the different “Video Status” modes.

Press the MENU button

π† To AUTO DEMO

è To turn AUTO DEMO ON or OFF

Note:

•To stop auto demo, press the MENU button, and select auto

demo by pressing the π† buttons, and turn it off by pressing the √® buttons. Press the MENU button to finish.

INITIAL SETUP

PREVIOUS

AUTO TUNER SETUP

CHANNEL SUMMARY

V-CHIP

SET LOCK CODE

AUTO DEMO	OFF
NEXT PAGE	(4/4)
SELECT OPERATE	MENU EXIT

31