JVC AV-14FMG3B, AV-14FMT3, AV-1438 VSM Preset Setting, VER. Scurve, Top, Tint Colour Bright Sharp

AV-14F3/AV-1435

AV-1435EE/AV-1435TEE

AV-14FMT3/AV-1438

AV-14FMG3/AV- 14FMG3B

Item	Measuring		Test point	Ad justment part			Description
	instrument
Ad justment	Signal			4. VER. L IN.		● When the	vertical linearity has	been	deteriorated
of VER. LIN.	generator			5. VER. SCURVE		remarkably, perform the following steps.
& VER.	Remote					15.Input a cross -hatch signal.
SCURVE	control unit
						16.Select 4. VER. LIN. with the MENU ▼/▲ key.
						17.Set the initial setting value of 4. VER LIN. with the MENU - / +
						key.
					TOP	18.Select 5. VER. SCURVE with the MENU ▼/▲ key.
						19.Set the initial setting value of 5. VER. SCURVE with the MENU
						- / + key.
					CEN TER	20.Adjust 4. VER. LIN. and 5. VER. SCURVE so that the spaces
						of each line	as shown in Fig.3 on	TOP,	CENTER and
					BOTTOM	BOTTOM become uniform.
						Make sure that the adjustment is properly done on the screen of
		Fig.3				60Hz mode.
						[NOTE]
						" Adjust to make both 50Hz & 60Hz are the same v. size and
						fine straight line.
						" When adjust again, adjust 50Hz mode first.
						" When adjust in 60Hz mode, only 60Hz mode is adjust.

VSM PRESET SETTING

Item

Measuring instrument

Test point

Ad justment part

Description

Setting of

VSM PRESET

Remote control unit

TINT COLOUR BRIGHT CONT .

SHARP

1.Enter the SERVICE MENU.

2.Select 4. VSM PRESET from the SERVICE MENU.

3.Select BRIGHT with the PICTURE MODE key.

4.Adjust the MENU ▼/▲ and MENU - / + key to bring the set values of TINT ～ SHARP to the values shown in the below table.

5.Respectively select the VSM PRESET mode for SOFT and STANDARD, and make similar adjustment as in 3 above.

BRIGHT

TINT**

COLOUR **

BRIGHT **

CONT. **

SHARP **

/	:SELECT
- / + : OPERATE		DISP : EXIT

•VSM PRESET

VSM	BRIGHT	STANDARD	SOFT
Setting Item
TINT	+15	←	←
COLOUR	+15	←	←
BRIGHT	+15	←	←
CONT	+30	+15	+11
SHARP	+15	←	+12

28 No. 52026