Using the Remote Control
Programming the Remote to Operate Your TV
Important: Make sure you start with the remote control's mode switch in the DIRECTV position. Keep the mode switch in that position until the on- screen directions tell you to move it.
To program the remote to operate your TV:
1.Press the MENU button on the remote control (the Quick Menu appears).
2.Select Settings from the Quick Menu.
3.Select Setup from the Settings menu.
4.Select Remote from the System Setup screen.
5.Select TV from the Remote Control Setup screen.
Make sure you know the brand of your TV. Follow the
Controlling a Second DIRECTV® Receiver
To program the remote to operate a second DIRECTV Receiver in the same room:
1.Press the MENU button on the remote control (the Quick Menu appears).
2.Select Settings from the Quick Menu.
3.Select Setup from the Settings menu.
4.Select Remote from the System Setup screen.
5.Select Receiver Mode from the Remote Control Setup screen.
Follow the
Important: You must program the remote to control another receiver in AV1 or AV2 mode before you change the Receiver Mode.
Mode switch
Operating Other Components
Once the remote has been programmed successfully, you are ready to use it to operate your components.
| ������������ |
�� | �� |
����� | ����� |
| �� |
| ��� |
To Operate the Component:
1.Set the mode switch to the correct position to control the component.
2.Press PWR to turn the component on or off.
3.Use the remote control buttons that apply to that component.
Note: Your remote’s buttons might operate differently for other components, especially when you’re using another component’s menu system.
Modes of Operation
Because this universal remote can control several different components (DVD player, VCR, etc.) it uses operational modes triggered by the mode switch. For example, if you want the remote control to operate the TV, set the mode switch to TV to put the remote into TV mode. If you've programmed the AV1 position to operate your DVD player, and you want the remote to operate the DVD player, set the mode switch to the AV1 position.
Chapter 2 | 17 |