Canon KV-2199XDK service manual Picture Tube Removal, ∙ Removal of ANODE-CAP ∙ Removing Procedures

2-8. PICTURE TUBE REMOVAL

3F board

4C3 board

7Neck assy

5 Deflection yoke

2 A board

6 Four screws (Tapping screws)

1Anode cap

– 21 –

Cushion

∙REMOVAL OF ANODE-CAP

NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.

∙REMOVING PROCEDURES

a

a

1Turn up one side of the rubber cap in the direction indicated by the arrow a.

b

b

2Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b. c

Anode button

3When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.

∙HOW TO HANDLE AN ANODE-CAP

1Do not damage the surface of anode-caps with sharp shaped objects.

2Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber.

3Do not turn the foot of rubber over too hard.

The shatter-hook terminal will stick out or damage the rubber.

KV-2199XDK

RM-952