Dell 21N21E2 service manual Disassembly Instructions, Removal, Installation

Page 9

DISASSEMBLY INSTRUCTIONS

1. REMOVAL OF ANODE CAP

Read the following NOTED items before starting work.

*After turning the power off there might still be a potential voltage that is very dangerous. When removing the Anode Cap, make sure to discharge the Anode Cap's potential voltage.

*Do not use pliers to loosen or tighten the Anode Cap terminal, this may cause the spring to be damaged.

REMOVAL

1.Follow the steps as follows to discharge the Anode Cap.

(Refer to Fig. 1-1.)

Connect one end of an Alligator Clip to the metal part of a flat-blade screwdriver and the other end to ground.

While holding the plastic part of the insulated Screwdriver, touch the support of the Anode with the tip of the Screwdriver.

A cracking noise will be heard as the voltage is discharged.

GND on the CRT

ScrewdriverCRT

Support

Alligator Clip

GND on the CRT

Fig. 1-1

2.Flip up the sides of the Rubber Cap in the direction of the arrow and remove one side of the support.

(Refer to Fig. 1-2.)

Rubber Cap

3.After one side is removed, pull in the opposite direction to remove the other.

NOTE

Take care not to damage the Rubber Cap.

INSTALLATION

1.Clean the spot where the cap was located with a small amount of alcohol. (Refer to Fig. 1-3.)

Location of Anode Cap

Fig. 1-3

NOTE

Confirm that there is no dirt, dust, etc. at the spot where the cap was located.

2.Arrange the wire of the Anode Cap and make sure the wire is not twisted.

3.Turn over the Rubber Cap. (Refer to Fig. 1-4.)

Fig. 1-4

4.Insert one end of the Anode Support into the anode button, then the other as shown in Fig. 1-5.

CRT

Support

Fig. 1-2

Support

CRT

Fig. 1-5

5.Confirm that the Support is securely connected.

6.Put on the Rubber Cap without moving any parts.

B1-1

Image 9
Contents Colourtelevision HOW to Order Parts Insulation Check ProcedureServicing Notices on Checking Contents System General SpecificationsA3-2 A3-3 A3-4 A3-5 Disassembly Instructions InstallationRemoval Removal and Installation of Flat Package IC B2-2 Service Mode List When Replacing Eeprom Memory ICConfirmation of Hours Used Constant Voltage Electrical AdjustmentsVCO Coase L1, VCO Fine L1 AGC VoltageHorizontal Position White BalanceVertical Size Vertical POSITION/VERTICAL LinearityNO. Function Contrast CentPurity Static Convergence Rough AdjustmentStatic Convergence Dynamic ConvergenceMain PCB CRT PCBBlock Diagram Printed Circuit Boards MAIN/CRT Inserted Parts Bshort Printed Circuit Boards MAIN/CRT Chip Mounted PartsAB6 SZPU8O MszpOB6D V7ED7YNXW SZP7OC8A XC7CXC6B SZP SZP XC6COT8 OT7C4A OC9B ZO C4CBD E4BQ8C TQM SZPPA6B YTQOA7C OA8AWaveforms 21PIN/AV SW Sound AMP CRT PCB Assy Mechanical Exploded ViewMechanical Replacement Parts List TSB P/N Resistors Electrical Replacement Parts ListJ2-2 CS0RF04L5Z CapacitorsJ2-4 Diodes ICS SwitchesTransistors Coils &TRANSFORMERSVariable Resistors Board AssembliesMiscellaneous