INSTALL WORK SURFACE AND SIDE BURNER
FOR THE PLATINUM SERIES II 3400 (CONTINUED)
Route the side burner hose so it will not interfere with the scale indicator rod.
The side burner hose is connected in the following manner:
Slide back the collar of the quick disconnect on the manifold. Push the male fitting of the side burner hose into the quick disconnect, and maintain pressure. Slide the collar closed. Figure 17. Figure 18 shows the quick disconnect engaged.
Male fitting
Manifold side view
Check that the side burner is properly assembled.
Windshield(c)
Burner
cap
| (b) | Burner |
|
| ring |
Grate | Lugs |
|
Slots
Burner
headIgniter electrode
(a)
Figure 17
Quick disconnect
engaged
Side burner | Manifold side view |
hose |
|
| Figure 18 |
Figure 20
Burner
base
Burner
orifice
WARNING: Set the burner ring onto the burner head. Rotate the burner ring until the four lugs on the burner ring are seated in the four slots on the burner head. Figure 20 (b).
Note: The burner head has a hole in it that fits over the igniter electrode.
After this assembly, proceed to step “Install Bottom Rack” on page 12.
To side burner To NG 
supply 
View from right
underside
Figure 19
11