Weber 3400 NG, 2200 NG Reinstall Control Panel, Refer to Operating Guide Before Lighting Barbecue

Page 15

REINSTALL THE

CONTROL PANEL

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Slip washers on Phillips screws, insert into holes as shown, and tighten. Figure 27 (a).

Push on the burner control knobs. Figure 27 (b).

(a)		(b)
	Underside view	Figure 27
	of right work	Figure 27
	of right work
	surface or side
	burner

REFER TO OPERATING GUIDE BEFORE LIGHTING BARBECUE

Image 15

Contents Platinum Series General Specifications for Piping Install GAS SupplyTools Needed Remove Bottom Tray from GrillSupplies Needed Remove Packaged Parts from Lower Carton Remove Grill from Lower PackagingReinstallation of Stainless Steel Flavorizer Bars Installation of Catch PAN Into Bottom TrayReinstallation of Warming Rack Reinstallation of Cooking GratesInstall WARM-UP Basket Install Work Surface and Side Burner Install Work SurfacesIgniter electrode To install side burner Burner Base Orifice Check That ALL Burner Valves are OFF Install Bottom RackCheck for GAS Leaks View from below Refer to Operating Guide Before Lighting Barbecue Reinstall Control Panel

Related manuals

Manual 24 pages 28.39 Kb