6.The decoded data appears after confirma- tion. You can go back to change the data. Select the corresponding input field using B 1 
CLEAR . Change the data with 0..9 .
7.When all information are correctly, press STATUS/EXIT . The programming information
is stored in a TIMER block.
Switching on 'VPS/PDC' in the 'START' input field
Select 'VPS/PDC' using B 1 
CLEAR . Press '1' to switch off 'VPS/PDC' or press '2' to switch on 'VPS/PDC'.
Recording from a satellite channel [VR830] If you want to record from a satellite channel, set ‘PROG.’ SAT with ‘2’. Then, enter the satel- lite programme number with 0..9 .
8.Insert a cassette with an intact security tab (unprotected).
Using 'Tape List'
To save a recording in 'Tape List' or to use a 'Tape List' cassette, enter the cassette number using 0..9 .
You can find more information on 'Tape List' in the chapter 'Tape List'. If you don't want to use Tape List, interrupt with STANDBY/ON y .
9.Switch off with STANDBY/ON y . The pro- grammed recording will only function when the video recorder is switched off with
STANDBY/ON y .
If any of the TIMER blocks are in use, ' REC' will light up on the video recorder display.
Problems and solutions for pro- grammed recordings
The video recorder will not operate
*While a programmed recording is being made, you cannot operate your video recorder manually. If you want to cancel the programmed recording, press C/A .
'TURN OFF VCR FOR TIMER RECORDING' flashes on the TV screen
*The video recorder was switched on several min- utes before the start of a programmed recording. Switch off the video recorder with STANDBY/ON y . A programmed recording (timer) will only function if the video recorder is switched off.
Cassette is ejected during recording
*The end of the tape was reached during record- ing.
Error message: ' 
' will flash in the video recorder display
*No cassette was inserted. Insert a cassette and switch off the video recorder using STANDBY/ON y .
Cassette was ejected as soon as the STANDBY/ON y button was pressed
*A cassette was inserted with the security tab removed.
Undo the erase protection (chapter 'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different cassette.
Error message: 'FULL'
*If this error message appears after pressing
, then all TIMER blocks are already pro- grammed. No more recordings can be pro- grammed. If you want to clear a programmed recording (TIMER block), select the programme number on TIMER LIST menu and press 
Programming a recording (without VIDEO Plus+ system)
1.Switch on the TV. If required, select the pro- gramme number for the video recorder.
2.Press MENU . The main menu will appear.
3.Select 'TIMER' with K B 
L C . Then press
B 1 .
4.Select ONCE, DAILY, or WEEKLY recording with K B 
L C . Then press B 1 .
If any of the TIMER blocks are in use, 'FULL' will appear on the TV screen.
SELECT K L CHOOSE B
→ONCE
DAILY WEEKLY TIMER LIST
END=EXIT
5.Select TIMER block with 0..9 .
Selecting once/daily/weekly recordings Use K B 
L C to select from the following options:
'ONCE': Recording once
'DAILY': Repeated daily recordings from Monday to Friday
'WEEKLY.': Repeated weekly recordings (every
week on the same day)
21 | EN |
|