CHAPTER 1 – GENERAL SYSTEM INFORMATION
USING THE REMOTE CONTROL
The remote control works very much like a television remote control. The remote control is used to move the camera right and left (pan), up and down (tilt), zoom in and out, adjust the volume and make video calls.
There are two sensors located on the bottom of the remote control. When you place the remote control down on the table, the image that you see on your monitor may change. To keep the image the same, lay the remote control on its side when not in use.
The word Far refers to the site(s) that you are connecting to over the PolyCom EX. This is commonly called the “Remote Site.”
The word Near refers to the site at which you’re located. This is commonly called the “Local Site.”
PolyCom EX User Manual | Aug. 18, 2004 v 1.1 | Page 3 of 13 |
Copyright © NORTH Network 1998.
The information herein may be reproduced provided that it is accurate and NORTH Network is credited as the source.