4.4 Video Cassette Recorder |
5 Installation
h) Connect the video recorder to the SCART input marked „VCR“. | ||||||||
| VCR | |||||||
If the receiver is turned on, press the VCR key | to | play a video cassette. If the receiver is in standby | ||||||
| ||||||||
mode (see 6.1) all audio and video signals are directed to the SCART outpu | t Netzpr | ovided the VCR | ||||||
produces an adequate switching signal. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4.5 Decoder
i)Plug the additional decoder to the SCART input marked „DECODER“.
You can toggle between four decoder signals to adapt to different decoding types.
Installation menu
>basic setting language outdoor unit satellite scan autom. satellite scan decoder/OSD childproof control feature ext. programmation
^/v/OK/STANDBY
Calling the installation menu |
| |
> Press | to switch the receiver to standby mode. | |
> Press | and | on the receiver at the same time and hold the keys down for appr. 2 |
secs. |
|
|
> Press | briefly. |
|
> Press | after terminating the settings to return to standby mode. |
5.1 Basic setting
You can use the following settings to reset the receiver to its „original state“. Consequently, all the changes and settings you have chosen will be undone. The
A: „flat“, B: Baseband, C: Video unapplied, D: Video.
Consult the decoder’s user manual to find out which signals are required and select the signal type according to the description in chapter 7.6, „Setting up the decoder“.
>Display the installation menu (see above)
> | Press | to set pointer to „Basic Setting“ |
> | Press | . |
OK
Basic setting
>delete all
load the pre-programmation
^/v/OK/STOP
8