Installation

Standard - AT1302, AT2002, AT2402, AT2702

-Please read the safety instructions in this manual completely before installation.

-Install your TV in an area where direct sunlight will not fall upon the screen.

-Soft, indirect light is best for television viewing.

-Allow enough space (at least 4 in.) between the TV and any wals or enclosures for proper ventilation.

-The optimum television viewing distance is 5-7 times the screen's vertical length:

13”	- 5 to 7 feet	24”	- 10 to 14 feet
20”	- 8 to 13 feet	27”	- 13 to 16 fet

Auto-Degaussing

Color television can be easily affected by magnetism, which shows as color distortion on the screen. If your TV is affected by nearby magnetic components or appliances, press the MAIN POWER SWITCH on the front of the TV to power off your TV for at least 1 hour. The built-in auto-degaussing circuit will eliminate the magnetic interference.

Connecting the Antenna

		75-ohm coaxial cable (not supplied)
	VHF	OR
	UHF	300-ohm twin-lead cable (not supplied)
	or Cable	300-ohm twin-lead cable (not supplied)
	or Cable
		Antenna adapter
		(not supplied)
	VHF
		OR
		U/V mixer
		(not supplied)
	UHF

Notes:

1.It is recommended that a 75 ohm coaxial cable be used in order to eliminate interference and noise which may occur due to nearby radio transmissions.

2.The antenna cable should not be tied together with other wiring.

3.Set up a lightning rod and check it regularly when an outdoor antenna is used.

Remote Control Battery Installation

1.Remove the battery compartment lid.

2.Insert two AAA batteries (included.) Make sure the positive (+) and negative (-) polarities are correctly aligned.

3.Reattach the battery lid.

Notes:

1.Alkaline batteries are recommended for longer life.

2.Always replace both batteries at the same time.

3.Do not expose batteries to fire or break them open.

4.To avoid battery leakage, remove batteries from the remote control when it is not to be used for a long period of time or the batteries are exhausted.

RF Input

(back of TV unit)