Loewe A 26, A 26 DVB-T, A 26 DVB-T CI operating instructions For your safety

Page 7

For your safety

For your safety and to avoid unnecessary damage to your TV set, please read and observe the following safety instructions:

• This TV set is designed exclusively for reception and reproduction of video and audio signals.

• This equipment is designed for domestic and office environments and must not be used in rooms with high humidity (e.g. bathroom, sauna) or high concentrations of dust (e.g. workshops). If the equipment is used in the open air, ensure that it is protected against moisture (rain, dripping, splashing, sprayed water or dew). Do not place any containers filled with liquids or lit candles on top of the TV.

High levels of moisture and concentrations of dust cause leakage cur- rents in the equipment, which can lead to danger of electric shock or fire.

The warranty is only valid for use in the specified permissible environ- ment.

• If you have moved the TV set out of the cold into a warm environment, leave it standing for about an hour because of the possible forming of condensation.

• This equipment must only be connected to a mains power supply which has the same voltage and frequency as that specified on the rating plate with the power cable provided. Incorrect voltages can damage the equipment.

• Like all electronic

equipment, your TV

 

 

 

 

 

 

 

 

10 cm

needs air for cooling.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Obstruction of the air

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

circulation can cause

5 cm

 

 

 

 

 

 

 

 

 

 

 

 

5

cm

fires. Therefore the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

air vents on the back

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

must always be kept

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

free. Please do not

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

place newspapers or

 

 

.

 

 

 

 

 

 

 

cloths on/over the TV.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If the TV is placed in a

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

cabinet or on a shelf,

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

leave at least 5 cm at the sides and 10 cm at the top to ensure sufficient air circulation.

Position the set so that it is not exposed to direct sunlight and addi- tional heating from radiators.

Avoid metal parts, needles, paper clips, liquids, wax or similar get- ting into the TV set through the air venting slits in the rear panel. This can lead to short-circuits and possibly to fire. If something should get into the inside of the TV set, pull out the plug immediately and notify customer service.

Never remove the back of the TV set yourself. Repair and servicing of your TV set should only be carried out by authorized TV technicians.

Place the TV set on a level, firm base. The set should not protrude at the front when installing in cabinets or shelves.

Only use original accessories if possible, e.g. Loewe wall holders and stands.

Never let children handle the TV unattended.

Do not allow children to play in the immediate vicinity of the TV, they could knock, shift or pull it over and injure someone.

Never leave the TV on unsupervised.

Do not install the TV where there may be vibrations. Vibrations can lead to material stress.

Pull out the power and antenna cables during thunderstorms. Surge voltages caused by lightning strikes can damage the TV through the antenna system and the mains. Also remove the antenna and mains plugs in long periods of absence.

The mains plug of the TV set must be easily accessible so that the set can be disconnected at any time.

Lay the cable in such a way that it will not be damaged. The power cable may not be kinked or laid over sharp edges, not stood on and not exposed to chemicals, the latter also applies to the device as a whole. A mains cable with damaged insulation can lead to electric shocks and is a fire risk.

When removing the power plug, pull the plug housing and not the cable. The wires in the plug could be damaged and cause a short circuit the next time it is plugged in.

The rating plate of the TV is on the rear of the set underneath the small flap for the headphones and camcorder connections.

7

Image 7
Contents Operating instructions Contents Remote control TV functions Menu up Control unitDigital audio input Component video inputs Common Interface Headphones connection VHS connection AVSConnections to rear panel SocketWelcome For your safety Connection First installationRemote control Switching onSwitching on the radio Switch on/offSwitching off Switching on the TV setChanging channels Daily operationGeneral information about the menu operation Setting the picture Adjusting the soundOperation on the TV set Modes of operation TV modeUnder Recording you will find the functions Modes of operation TVTV menu Call up the TV menuPicture in picture PIP Modes of operation PIPSelect Type and then Split Screen Switch to split screenFunctions in the PIP menu Split ScreenModes of operation EPG Using the EPGProgram guide EPG Data entry Switch on TV when markedCall EPG menu Selection of provider/stationModes of operation Teletext Teletext modeRadio menu Radio modeProgram timer recordings Teletext menuConnecting video/DVD recorders Login and connect equipmentOperating additional equipment Calling AV stations with the station table Timer recording with video or DVD recorderVideo playback Now you will see the playback from the connected AV unitAudio input Audio Digital Assignment of digital audio inputs and outputsAudio output Audio Digital OUT AV2 Connecting other audio amplifiers or active speakers VGA/XGA connection Hdmi DVI connectionSet color standard Select COMP. in sockets and with Call up Component Video connectionSound from PC or Set Top Box Log in the Component device in the connection wizardFunctions for Loewe video recorders VV 8106, 8136 Select the device to be operatedWhat to do, if Problem Possible cause HelpSet PCM stereo on the DVD player Stored at program places ∗Wrong character set is set in the teletext Character setConnections Technical dataMechanical data Electrical dataAvailable accessories Benelux Service-addresses