Before Switching on your TV
Power connection
IMPORTANT: The TV set is designed to op- erate on 230V AC, 50 Hz. &$%/(79
• After unpacking, allow the TV set to reach the ambient room temperature before you con- nect the set to the mains.
Connections to the RF input socket
795(VHF$53/UHF$1(/
•Connect the aerial or cable TV plug to the RF input socket located at the back of the TV and connect the cable plug coming out from the TV out socket located at the devices (VCR, DVB etc.) to this socket as well.
How to connect other devices
IMPORTANT: Switch off the TV before con- necting any external device.
Sockets for external connections are at the back and front of the TV. For connection of other devices via Euroconnector refer to the manuals of the related devices.
Inserting batteries in the remote control handset
•Place the batteries in the right directions as seen below.
•Remove the battery cover located on the back of the handset by gently pulling up- wards from the indicated part.
•Insert two LR03 AAA or equivalent type bat- teries inside.
•Replace the battery cover.
-6 -
NOTE: Remove batteries from remote con- trol handset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of batteries.
Switching the TV ON/OFF
To switch the TV on
Your TV will switch on in two steps:
1- Press the power button located on the front of the TV. Then the TV switches itself to standby mode and the RED LED located below the TV turns on.
2- To switch on the TV from
Press a digit button on the remote control so that a programme number is selected,
or,
Press Programme Up or Down buttons on the front of the TV or on the remote control, so that last switched off programme is se- lected.
By either ways the TV will switch on and the RED LED will turn GREEN.
To switch the TV off
•Press the
or,
Press the power button located on the front of the TV, so the TV will switch off and the GREEN LED will turn off.