Loewe Spheros R 32 HD+ manual Explanations of the setting possibilities, DVB-S line

Page 12

Initial installation

Explanations of the setting possibilities:

Location Select the country for country-specific pre-settings. of TV set

Antenna

Antenna/cable (analogue): analogue stations via

selection

DVB-T:

cable/antenna

 

digital, terrestrial stations

 

DVB-C:

digital stations via cable

 

DVB-S (line 1):

digital stations via satellite

 

DVB-S (line 2):

digital stations via satellite

DVB-T:

If you are using an active antenna, then select yes (5V)

Antenna

for the antenna power supply.

DVB-C:

The conventional settings will be derived from the selec-

Settings

tion of set location. Only change this if you know other

 

symbol rates and modulation types or if you have to spe-

 

cify the network ID for your cable network (information

 

available from your cable network provider). If you want

 

to run the station search independently of the channel

 

grid, select frequency search for the search method.

DVB-S:Select which satellite(s) you receive from a list. For more

Satellite

than one satellite, select the type of your changeover

system

switch or communal satellite system additionally.

 

Ask your dealer in this regard.

High band

Specify here whether the high band of the selected satel-

 

lite is to be searched in addition to the low band.

LNC

Normally, you do not need to change the values for high

frequencies

and low band, unless the LNC (LNB) of your satellite

Low Band /

system uses a different oscillator frequency (important

High Band

for the frequency display).

 

After you have made these settings, you should receive

 

the picture and sound of the selected satellites (only with

 

Astra1 and HOTBIRD).

 

Symbol rates

The symbol rates are specified by the satellite provider

 

and normally do not need to be changed.

Favoured

Select the signal source that provides the stations to be on

signal source

top of your station list (starting with station slot 1).

Start search Start the automatic station search with OK.

First TV stations, then radio stations are searched for.

The stations found in the automatic search are divided into the appropriate station blocks depending on the previously selected antenna cables (signal sources). Sub- sequently the stations can only be re-sorted within these blocks. At the beginning of the station list you will find the block with the stations of the preferred signal source.

Any mixed sorting of stations from different signal sources is only possible with the favourites list.

Connecting In conclusion the connection wizard and the sound com- additional ponents wizard will start; with their help you can register devices and set your video devices, decoders, speaker system, or a HiFi/AV amplifier and connect them to the TV set.

DVD players and DVD recorders are already registered at the factory.

You can start the connection wizard and the sound components wizard manually later and add new devices. Further information is available from page 35 (Connection wizard) and page 39 (Sound components wizard).

Digital Link If you have registered and connected a recorder in the Plus connection wizard, the Digital Link Plus transmission begins at the end of the sound components wizard. If a Digital Link Plus capable recorder is connected, the station list of the analogue stations is transmitted to the

external recorder.

You can also call Digital Link Plus under TV menu Con- nections Digital Link Plus.

If you have not connected a Digital Link Plus capable recorder, you can abort the transmission.

Explanations of the DVB-T antenna:

Room

With good reception conditions a room antenna can be

antenna

used for DVB-T (socket ANT2).

Active

Under less favourable reception conditions, it is advisable

antenna

to use an active antenna which has to be set accordingly

 

in the initial installation or in the TV menu Connections

 

Antenna DVB Antenna DVB-T (see DVB-T antenna

 

on this page).

Unidirectional

If the location is outside of the normal transmission

antenna

range then a directional antenna can be used to improve

 

reception quality.

- 12

Image 12
Contents Operating Instructions Contents Remote Control TV Functions Control unit front side of the device Factory settings Connections rear side of the deviceSD/HD-COMPONENT in Cb/Pb-Cr/Pr-Y component video inputs Welcome Operating convenience with wizards Wizards in overviewInfo display and TV index For your safety Power supplyAir circulation and high temperatures Proper use and environmental conditionsRepairs and accessories VolumeCleaning SupervisionInitial installation Installing the TV setPreparing the remote control unit Connecting the TV setFirst installation wizard Turning the set on/offExplanations of the setting possibilities Antenna/cable analogue analogue stations viaDVB-S line Explanations of the DVB-T antennaPositioning/aligning DVB-T antenna General information on menu operationOperating convenience Info displayIndex in the TV set TV menu Overview diagram Radio menu Overview diagramDaily operation Select stationSelect video source Adjusting the sound Adjusting the picture Operation without remote controlButton functions Explanations of the symbols for sound identification Status displayAdditional selection possibilities for DVB stations Yellow button Time selection Blue buttonManaging stations TV stationsSearch/update station manual search Change, delete, move, rename, restore stations3456or numeric buttons Delete stationPut together change favourites lists Add station to favourites list Delete station from favourites listRed button Activates Clear favourite list Move / change order of stations in the favourites listPicture in Picture Picture in Picture PIPConfigure Picture in Picture PIP mode Electronic Programme Guide Electronic Programme Guide EPGConfiguring EPG Calling additional information about the programmesProgramming a recording for a recorder Start the EPG menuTeletext TeletextProgramming timer recordings via Teletext Teletext menuStarting the Teletext menu Explanations of the Teletext menu functionsConditional Access Module CA module Software update Radio mode RadioConnecting additional devices to the TV set Operating additional equipmentDevice connection wizard Call TV menu 34Select ConnectionsExplanations of important settings Connecting antenna to the DVD/video recorderConnection possibilities for a DVD/video recorder Manual station searchConnecting devices to the PC in connection and playback Digital audio signal Digital audio signal must be assigned via the TV menuAV sockets 34Select and adapt the GeometrySound components wizard Integrated Dolby Digital DecoderSetup ConnectingAdjusting the speaker system Calling the sound components wizard34Select Sound components Sound playback via ... speakers system34Select Configuration/modification 34Select External speakersOK continue to Adjust speaker level OK continue to Subwoofer phaseOK continue to set Distance to left front speakerConnecting audio amplifiers Connecting digital audio amplifiersConnecting analogue audio amplifiers Mark the HiFi/AV amplifierAssignment of the digital audio input Audio connection in Hdmi DVI devicesDirect way to record Timer recording with external devices PhotoViewer Open folder Marking photos for slide showStarting a slide show Calling the PhotoViewer menuUsing the remote control for a DVD player Using the remote control for a recorderUsing the remote control for the TV set Operating Loewe equipmentRotating the TV set Troubleshooting Connection diagram Available is output Connection diagramWith Teletext various character sets are AmplifierTechnical data General dataElectrical data ConnectionsAccessories AccessoriesSetup possibilities Conditional Access Module See CA module GlossaryCinch cable Cable for transmitting audio or video CI slot See Common InterfaceJPG See Jpeg Picture in Picture see PIPOffers the user additional use possibilities TV analogue TV digitalHD analogue HD digitalIndex Service Somara S.A