Loewe Spheros R 32 HD+, Spheros R 37Full-HD+ manual Conditional Access Module CA module

Page 32

DVB

Conditional Access Module (CA module)

In order to receive coded digital stations, a Conditional Access Module (CA module) and a Smart Card must be inserted in the CI slot of your TV set (see page 5).

The CA module and the Smart Card are not part of the TV set's scope of delivery. They are usually available from your dealer.

Inserting the Smart Card into the CA module

Push the Smart Card into the CA module as far as it goes so that the side with the gold coloured contact chip is facing the side of the CA module marked with the provider's logo. Note the direction of the arrow printed on the Smart Card.

Inserting the CA module in the CI slot

Switch off the TV set's mains switch. Remove the cover from the rear of the set.

Ejector button

Cover

Carefully insert the CA module in CI slot 1 or CI slot 2 with the contact side forward.

If you are standing in front of the TV set (display) then the logo on the CA module must be pointing to the rear. Do not use force. Make sure the module is not twisted in the process.

If the CA module is correctly installed, the ejector button protrudes a little further.

Switch on the TV set

The following dialogue appears:

 

 

 

 

Search wizard

END

 

Your TV set hast detected a new CA module. This requires a

 

station search for all new receivable station

 

 

 

Continue with OK

 

 

 

 

OK start the search wizard.

Check the recommended search routine parameters and then start the search.

Replace the cover.

Calling CA module information

This menu is only available for digital stations.

Call TV menu.

34Select Settings,

6 go to the menu line below.

34Select Miscellaneous,

6go to the menu line below.

34Select CA module: xxx

(xxx corresponds to the CA module provider), OK to call information.

The content of this menu depends on the provider of the CA module.

Removing the CA module

Switch off the TV set's mains switch.

Remove the cover from the rear of the set.

Press in the ejector button on the appropriate module drawer, the module is released.

Remove the module from the set. Replace the cover.

- 32

Image 32
Contents Operating Instructions Contents Remote Control TV Functions Control unit front side of the device SD/HD-COMPONENT in Cb/Pb-Cr/Pr-Y component video inputs Factory settingsConnections rear side of the device Welcome Info display and TV index Operating convenience with wizardsWizards in overview For your safety Power supplyAir circulation and high temperatures Proper use and environmental conditionsRepairs and accessories VolumeCleaning SupervisionInitial installation Installing the TV setPreparing the remote control unit Connecting the TV setFirst installation wizard Turning the set on/offExplanations of the setting possibilities Antenna/cable analogue analogue stations viaDVB-S line Explanations of the DVB-T antennaPositioning/aligning DVB-T antenna General information on menu operationIndex in the TV set Operating convenienceInfo display TV menu Overview diagram Radio menu Overview diagramDaily operation Select stationSelect video source Adjusting the sound Adjusting the picture Operation without remote controlButton functions Explanations of the symbols for sound identification Status displayAdditional selection possibilities for DVB stations Yellow button Time selection Blue buttonManaging stations TV stationsSearch/update station manual search Change, delete, move, rename, restore stations3456or numeric buttons Delete stationPut together change favourites lists Add station to favourites list Delete station from favourites listRed button Activates Clear favourite list Move / change order of stations in the favourites listPicture in Picture Picture in Picture PIPConfigure Picture in Picture PIP mode Electronic Programme Guide Electronic Programme Guide EPGConfiguring EPG Calling additional information about the programmesProgramming a recording for a recorder Start the EPG menuTeletext TeletextProgramming timer recordings via Teletext Teletext menuStarting the Teletext menu Explanations of the Teletext menu functionsConditional Access Module CA module Software update Radio mode RadioConnecting additional devices to the TV set Operating additional equipmentDevice connection wizard Call TV menu 34Select ConnectionsExplanations of important settings Connecting antenna to the DVD/video recorderConnection possibilities for a DVD/video recorder Manual station searchConnecting devices to the PC in connection and playback Digital audio signal Digital audio signal must be assigned via the TV menuAV sockets 34Select and adapt the GeometrySound components wizard Integrated Dolby Digital DecoderSetup ConnectingAdjusting the speaker system Calling the sound components wizard34Select Sound components Sound playback via ... speakers system34Select Configuration/modification 34Select External speakersOK continue to Adjust speaker level OK continue to Subwoofer phaseOK continue to set Distance to left front speakerConnecting audio amplifiers Connecting digital audio amplifiersConnecting analogue audio amplifiers Mark the HiFi/AV amplifierAssignment of the digital audio input Audio connection in Hdmi DVI devicesDirect way to record Timer recording with external devices PhotoViewer Open folder Marking photos for slide showStarting a slide show Calling the PhotoViewer menuUsing the remote control for a DVD player Using the remote control for a recorderUsing the remote control for the TV set Operating Loewe equipmentRotating the TV set Troubleshooting Connection diagram Available is output Connection diagramWith Teletext various character sets are AmplifierTechnical data General dataElectrical data ConnectionsSetup possibilities AccessoriesAccessories Conditional Access Module See CA module GlossaryCinch cable Cable for transmitting audio or video CI slot See Common InterfaceOffers the user additional use possibilities JPG See JpegPicture in Picture see PIP TV analogue TV digitalHD analogue HD digitalIndex Service Somara S.A