Panasonic PV-V4525S warranty Tape Select, Commercial Skip, Tape Position and Tape Status Display

Tape Operation

Tape Select

Select your tape length so the tape position and amount of tape remaining are properly displayed. (See “Tape Position and Tape Status Display” section below.)

1Press ACTION to display menu.

2		MENU		Press	to select
	SET UP VCR			“SET UP VCR,”
	SET UP CLOCK
	SET UP CHANNEL			and press .
	VCR’S OUTPUT CH: 3
	IDIOMA/LANGUE : ENGLISH
	SELECT :		SET:
	EXIT	: ACTION
		SET UP VCR		Press	to select
3 REPEAT PLAY			: OFF	“TAPE SELECT,” and
	AUTO SHUT-OFF		: OFF
	FRONT DISPLAY		: ON	press	to set “T-120,”
	AUTO VCR/TV		: ON
	TAPE SELECT		: T-120	“T-160” or “T-180.”
	SELECT :		SET:	T-120	T-160	T-180
	EXIT	: ACT I ON

•Select “T-120” for tapes 120 minutes or less, “T-160” if 140 or 160 minutes, and “T-180” if 180 minutes.

4Press ACTION

to return to normal screen.

Commercial Skip

VCR fast forwards (skips) over 1, 2, or 3 minutes of recorded tape as desired.

1Press CM/ZERO in Play mode.

•Press CM/ZERO repeatedly to change skip time as shown below.

PLAY

1st Press 1 min Skip

2nd Press 2 min Skip

3rd Press 3 min Skip

• No indication appears.

• Tape Operation

Tape Position and Tape Status Display

To find out the present tape position and amount of tape remaining.

Tape position is displayed incorrectly in the following cases:

•If VHS-C type cassettes, tapes under 30 minutes, tapes over 180 minutes, or incompatible tapes are used.

•If the correct tape length is not selected. (See “Tape Select” section above.)

1 Press TAPE POSITION to detect tape position.

DETECTING TAPE POSITION

SP

R 120 MI N.

BEGI NEND

•“DETECTING TAPE POSITION” only appears the first time a cassette is inserted and it takes several seconds for correct indication to appear.

•The present tape position indication and amount of tape remaining (according to tape speed) are displayed.

Tape remaining time display may not be precise.

2Press TAPE POSITION (or wait 5 seconds) to return to normal screen.

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

- 7 -