Connections / Initial Setup (Ready to Play)
Make all cable or antenna connections before plugging into an AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
Connecting (Select a method)
For ANT./Cable ➛ VCR ➛ TV
1Connect cable from Antenna/Cable to VCR’s IN FROM ANT. jack.
2Connect VCR’s OUT TO TV jack to TV’s ANT. IN jack with included RF Cable.
For DSS/Cable Box ➛ VCR ➛ TV
1 Connect your cable box’s OUT jack to the VCR’s IN FROM ANT. jack with an RF cable.
2Connect VCR’s OUT TO TV jack to TV’s ANT. IN jack with included RF Cable.
1
2
1
2
Over tightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
1
2Plug VCR Power Cord into AC wall outlet. VCR comes on and auto channel and clock set starts.
•If screen below does not appear...
check all connections.
Try tuning TV to channel 4.
•To change VCR’s output channel, see “VCR’s Output Channel” (p. 12) in Advanced Operations book.
Plug VCR Power plug into an AC wall outlet.
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
If you use a cable box, turn it on and set it to the Public Broadcasting Station (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.
Notes
•Function buttons are void during Initial Setup.
•To eject a tape during Auto Set, press EJECT on remote or STOP twice on VCR.
Then make settings manually.
(See Advanced Operations book, p. 12.)
•If Auto Clock Set takes more than 30 minutes, press STOP and perform settings manually. (See Advanced Operations book, p. 12.)
3 Settings are made automatically. When complete, this screen appears.
If “AUTO CLOCK SET IS INCOMPLETE” appears, manually set clock (below).
AUTO CLOCK SET
IS I NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACT I ON KEY
Manual Clock Set
If Auto Clock Set was incomplete.
1 Press ACTION* on remote to display CLOCK menu.
2 Press 
to select the month and 
to set. In the same manner, select and set the date, year, time, and DST (Daylight Saving Time).
3 Press ACTION to start clock and exit.
- 4 -