Panasonic AJ-SD930, AJ-SD955A $ Commands relating to inquiries, CTL/TC Data STX QCD ETX, Request

RS-232C interface

$ Commands relating to inquiries

<Notes>

O As for the return (completion) message, [ACK] is first returned when data is received, and the execution message is subsequently returned. It is only the execution message which is listed in this table.

O In the case of commands not listed in the table, ER001 (invalid command) is returned after [ACK] has been returned.

VTR	Send command					Return (completion)
operation							message
CTL/TC DATA	[STX] QCD [ETX]				45 [STX] CD data [ETX]
REQUEST
	This command is for inquiring about the counter
	value.
	data = f w gh mm ss ff
		f	= F
		w	= S
		gh =
	CTL mode:
		g = SP (20h) : for a plus display
			– (2Dh) : for a minus display
		h	= 0 – 9			: hours
	TC mode:
		gh	= 00 – 23			: hours
		mm = 00 – 59				: minutes
		ss	= 00 – 59			: seconds
	[525i system]
		ff	= 00 – 29			: frames
	[625i system]
				SD955A
		ff	= 00 – 24			: frames
	<Note>
	CTL or TC is returned, whichever corresponds to
	the front display mode.
STATUS	[STX] QOP [ETX]				45		[STX] 222 [ETX]
REQUEST
	This command is for inquiring about the VTR’s
	operation mode.
	222 =
	OEJ	: EJECT
	OFF	: FAST FORWARD
	OPL	: PLAY
	ORC : REC
	ORW : REWIND
	OSP : STOP (including the STANDBY ON)
	SRS	: (IN/OUT) PREROLL
	OBF	: STANDBY OFF
	OSF	: SHTL FORWARD
	OSR	: SHTL REVERSE
	OJG : JOG FORWARD/REVERSE
	OSW : VAR FORWARD/REVERSE
	EAE : AUTO EDIT
	EON : EDIT ON (MANUAL EDIT)
	EPV : PREVIEW
	ERV : REVIEW
ID (VTR No.)	[STX] QID [ETX]				45		[STX] data [ETX]
REQUEST
	This command is for inquiring about the VTR
	used.
	data = AJ-SD930P
	or
	AJ-SD955AP
				SD955A

73