Panasonic AJ-SD955A, AJ-SD930 Sdti interface, Precautions to observe when using the Sdti signals

SDTI interface

Digital data input/output operations using the SDTI format (compressed digital interface) are enabled by installing the AJ-YAC930G SDTI board (optional accessory) in this unit.

Source

Reference signal

generator

<Notes>

SDTI (Serial Data Transport Interface) complies with the SMPTE 305M standard.

The data stream format transferred via the SDTI complies with the SMPTE 321M standard.

AC IN

SIGNAL

GND

AES/EBU
CH1/2		VIDEO
IN
		IN
		ON
CH3/4	Y	75Ω
IN		OFF
CH1/2	PB	REF VIDEO
OUT		IN
		ON
CH3/4	PR	75Ω
OUT	OPTION	OFF
Y	1	VIDEO
		OUT

PB2 (WFM)

PR3

REMOTE

REMOTE IN/OUT

REMOTE OUT

ENCODER REMOTE

RS-232C

PARALLEL

	ANALOG
CH1 PUSH AUDIO PUSH CH2			PUSH	TC
	IN			IN
CH3 PUSH		PUSH CH4		TC
				OUT
CH1	AUDIO	CH2		MON
	OUT			L
CH3		CH4		MON
				R

	SDI
IN	OUT

1

ACTIVE

THROUGH

2

3

(SUPER)

OPTION

SDTI

IN OUT

1

2

Precautions to observe when using the SDTI signals

O The unit can record only if the SDTI input signals are 1a transfer signals in the DVCPRO50 or DVCPRO format selected by setup menu No. 012

SERVICE ONLY

SDTI signals

(SYS FORMAT).

However, when playback signals other than normal 1a playback signals have been input, recorded and EE picture and sound are not guaranteed.

O Editing operations can be performed only when all the video and audio signals as well as the time codes in the SDTI input signals are regular data based on the DVCPRO50 or DVCPRO format

Recorder

AC IN

SIGNAL

GND

AES/EBU
CH1/2		VIDEO
IN
		IN
		ON
CH3/4	Y	75Ω
IN		OFF
CH1/2	PB	REF VIDEO
OUT		IN
		ON
CH3/4	PR	75Ω
OUT	OPTION	OFF
Y	1	VIDEO
		OUT

PB2 (WFM)

PR3 (SUPER)

REMOTE

REMOTE IN/OUT

REMOTE OUT

ENCODER REMOTE

RS-232C

PARALLEL

	ANALOG
CH1 PUSH AUDIO PUSH CH2			PUSH	TC
	IN			IN
CH3 PUSH		PUSH CH4		TC
				OUT
CH1	AUDIO	CH2		MON
	OUT			L
CH3		CH4		MON
				R

	SDI
IN	OUT
	1
	2
	3
	(SUPER)
	SDTI
IN	OUT
	1
	2

selected by setup menu No. 012 (SYS FORMAT). O CUE signals are not transferred by the SDTI

interface.

O SDTI dubbing is not possible from tapes recorded using the DV or DVCAM format.

Use SDI when dubbing tapes recorded in the DV or DVCAM format.

O When playing back a DV or DVCAM format tape, DV compressed signals (Compliant with IEC61834- 2.) serve as the SDTI output.

O The video and audio signals in the SDTI output signals cannot be adjusted.

O During SLOW/STILL playback, the unprocessed video and audio signals are output as the SDTI output.

When these video and audio signals are to be monitored using another device, they may differ from the video and audio signals played back by this unit.

SERVICE ONLY

Connections involving two units

74