Panasonic NV-MV20 Series Timer recording, Automatic SP/LP selection, VPS/PDC function

Page 11

Timer recording

SV120 HV60 HV65 HV55 HV50 MV20 MV15

Automatic SP/LP selection

A:If, at the beginning of a timer programme, there is not enough tape remain to complete it, the SP/LP function will automatically run the tape at LP speed. This ensures that the entire programme will be recorded. If the LP mode is not enough to 'stretch' the remaining tape to fit you will not be able to record all of the TV programmes.

DIt is not possible to automatically activate the EP mode.

	SV120 HV60 HV65 HV55 HV50 MV20 MV15
	VPS/PDC function
VPS/PDC	This setting defines how a special signal controls the beginning and end of
	a recording session. If a TV programme begins or ends earlier or later than
	planned, this function synchronises the beginning and end of the recording
	session with the actual beginning and end of the TV programme.
	ON : The station transmits VPS/PDC signals. You must set the timer to the
	time specified in the TV magazines. Use the special VPS time the TV
	magazine may indicate.
	- - - :The station does not transmit VPS/PDC signals. Try to set the start and
	stop times such that the entire film can be recorded even if a programme
	begins or ends earlier or later than planned.

11

Image 11

Contents NV-MV20Series Mono / NV-MV15Series Mono Operating InstructionsNV-HV55Series Hi-Fi NV-HV50Series Hi-Fi Contentspage PrecautionsNorsk Playback Remote control functionsControl menu Playback functionsAudio Timer3D DNR Front PanelCVC Super Rear Panel Connections / Settings Enter Auto SetupSV120 HV60 HV65 HV55 HV50 MV20 MV15 Recording Tape Remain counter/indicatorVPS/PDC function Timer recordingAutomatic SP/LP selection PROG/CHECK Enter Timer recordingProg Play Playing back programmed recordings Quitting the timer modeChecking the timer programme Changing or cancelling a timer programmeShowView TimerEditing the Timer recording data Timer EnterEditing a programme Intelligent TimerFinding the start of a recording Audio settingsGeneral functions Repeat playbackErasing a cassette OFF Timer Limiting the recording and playback time3D DNR, 3-Dimensional Digital Noise Reduction Selected menu is displayed Menu OverviewSetting a new Channel Manual SetupMenu Changing the name of TV stationsChanging the order of TV stations or deleting a station Creating a new station table Shipping condition / restoring factory defaultsOSD Menu OthersAV2 AV1 OUTVHS ET REC Power saveVCR display VHS RECSV120 HV60 HV65 HV55 HV50EC HV50EG/EP MV20 MV15 Connecting a decoderSetting the channel to Decoder DecoderExternal recording control External recording controlConnect an amplifier AmplifierNicam sound system Ntsc playbackCassette erasure protection Inserting batteries into the remote control unitBefore requesting service Model No Serial No SV120 HV60 HV65 HV55 HV50 MV20 MV15 Power consumption SpecificationsThese specifications are subject to change without notice Power supply AC, 50/60 HzDecoder Index