Panasonic NV-HV65 Series, NV-HV60 Series, NV-MV20 Series, NV-HV55 Series Connections / Settings

Page 8

Connections / Settings

VCR

Aerial

RF-Coaxial Cable

21-pin Scart Cable

Connect all the cables as shown in the illustration, then connect the AC Mains lead (part of the package) to an AC wall outlet.

To be able to receive TV programmes it is mandatory to connect the RF-Coaxial Cable even if the video recorder is connected by a 21-pin scart cable.

If you decide to just use the RF-Coaxial Cable to connect the TV set you must adjust the video output channel with the TV set's input channel.

! Switch on the video recorder

!Press the MENU button for approx. 7 seconds. The preset channel appears on the display.

!Tune the TV set until the test pattern appears.

If there is any interference select another channel for the TV set and

	video recorder.
!	Press the CH button to change the channel (e.g. to 39).	CH
!	Tune the TV set until the test pattern appears.

!Press ENTER to confirm.

Image 8

Contents NV-MV20Series Mono / NV-MV15Series Mono Operating InstructionsNV-HV55Series Hi-Fi NV-HV50Series Hi-Fi Precautions ContentspageNorsk Remote control functions Control menuPlayback functions PlaybackTimer Audio3D DNR Front PanelCVC Super Rear Panel Connections / Settings Enter Auto SetupSV120 HV60 HV65 HV55 HV50 MV20 MV15 Tape Remain counter/indicator RecordingVPS/PDC function Timer recordingAutomatic SP/LP selection Timer recording PROG/CHECK EnterQuitting the timer mode Checking the timer programmeChanging or cancelling a timer programme Prog Play Playing back programmed recordingsTimer Editing the Timer recording dataTimer Enter ShowViewIntelligent Timer Editing a programmeAudio settings General functionsRepeat playback Finding the start of a recordingErasing a cassette OFF Timer Limiting the recording and playback time3D DNR, 3-Dimensional Digital Noise Reduction Menu Overview Selected menu is displayedManual Setup Setting a new ChannelMenu Changing the name of TV stationsChanging the order of TV stations or deleting a station Shipping condition / restoring factory defaults Creating a new station tableMenu Others AV2AV1 OUT OSDPower save VCR displayVHS REC VHS ET RECConnecting a decoder Setting the channel to DecoderDecoder SV120 HV60 HV65 HV55 HV50EC HV50EG/EP MV20 MV15External recording control External recording controlAmplifier Nicam sound systemNtsc playback Connect an amplifierInserting batteries into the remote control unit Cassette erasure protectionBefore requesting service Model No Serial No Specifications SV120 HV60 HV65 HV55 HV50 MV20 MV15 Power consumptionPower supply AC, 50/60 Hz These specifications are subject to change without noticeIndex Decoder