Multiquip GB114BW manual Globug Solo Lighting System PRE-SETUP

GLOBUG SOLO LIGHTING SYSTEM — PRE-SETUP

CAUTION - READ MANUAL

Please read this entire manual carefully before attempting to operate the GloBug Solo. Failure to read this manual could cause damage to the GloBug Solo and serious injury to the operator.

GloBug Solo Setup

1.Place the GloBug Solo on a firm level surface so that it will not slide or turn over. Make sure there is enough space around the GloBug Solo for the outriggers to be deployed.

2.Lock the three caster wheels (two wheels have no locks) by stepping on the red end (S) of the caster lever (Figure 7).

Figure 7. Locking Caster Wheels

3.Pull outriggers downward at the ends until they lock in place in the ground (Figure 8).

4.Expose the balloon by pulling down on the velcro tabs and unzipping the protective cover as shown in Figure 9. Next, fold the protective cover into itself and zip.

Figure 9. Exposing the Balloon.

5.Before raising the mast, make sure the T-Handle Bolt Lock (Figure 10) is securely tightened. This will prevent the balloon/lamp assembly from falling off. In addition make sure that the lamp power cable (balloon) is connected to the lamp power cable (ballast).

6.Push down the mast and unhook the Mast Release Latch (Figure 10). Extend the mast to the desired height.

Figure 10. T-Handle Bolt Lock and Mast Release Latch

Figure 8. Outriggers (DeployedPosition)

DANGER SPRING LOADED MAST

The mast is spring loaded and will automatically extend when unhooked. NEVER extend the mast with balloon or lamp removed. The possibility exists of the mast rapidly shooting upward.

PAGE 16 — GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09)