Pelco C1602M installation manual Prepare Unit for RAM Installation, Open the Unit Chassis

Page 7

Prepare Unit for RAM Installation

OPEN THE UNIT CHASSIS

WARNING: The chassis assembly includes parts with sharp edges. To avoid injury, use caution when working in and around the DX8000’s chassis and components.

1.If the DX8000 is mounted in a rack, remove it and transport it to an area that will provide full access to the unit chassis:

a.Disconnect any cables or connections that might restrict access to or the removal of the unit.

b.Unscrew the fasteners that are securing the unit in the rack.

c.Carefully lift the unit out of the rack.

NOTE: Removing the DX8000 from a rack may require more than one person. Refer to the DX8000

Installation Manual for rack mounting information.

2.Place the DX8000 on a flat surface with ample workspace.

C1602M (6/04)

5

Image 7
Contents DX8000-256RAM Installation Manual Page Introduction Parts ListGetting Ready Removing Power Cord from WallRemoving Power Cord from Unit ESD Protection Open the Unit Chassis Prepare Unit for RAM InstallationRemoving Chassis Cover Component Layout First Empty Dimm Socket Install the DX8000-256RAM Memory ModuleDimm Module and Dimm Socket Alignment Seating and Securing the Dimm Module Replacing Chassis Cover Reassemble the UnitProduct Label Restarting the Unit Windows 2000 Control Panel Double-click the System icon Verify Installation of New RAMVerify that the amount of RAM is now 512 MB. Refer to Figure C1602M 6/04 Product Warranty and Return Information ISO9001