Pelco C1602M installation manual Removing Chassis Cover

Page 8

3.Using a Phillips-head screwdriver, remove the chassis cover:

WARNING: Make sure unit is turned off and you are wearing a properly grounded ESD wrist strap before attempting to open the DX8000 chassis cover. Refer to the Getting Ready section.

a.Remove the two top-most screws on the left and right side panels of the DX8000. Refer to Figure 5.

b.Remove the four silver screws fastening the cover to the rear of the unit. These screws are the ones closest to the top of the unit. Refer to Figure 5.

c.Carefully remove the chassis cover by sliding it back and up. Set aside the cover. Figure 6 illustrates the interior of the DX8000.

Figure 5. Removing Chassis Cover

6	C1602M (6/04)

Image 8

Contents DX8000-256RAM Installation Manual Page Parts List IntroductionRemoving Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for RAM Installation Open the Unit ChassisRemoving Chassis Cover Component Layout Install the DX8000-256RAM Memory Module First Empty Dimm SocketDimm Module and Dimm Socket Alignment Seating and Securing the Dimm Module Reassemble the Unit Replacing Chassis CoverProduct Label Restarting the Unit Verify Installation of New RAM Windows 2000 Control Panel Double-click the System iconVerify that the amount of RAM is now 512 MB. Refer to Figure C1602M 6/04 Product Warranty and Return Information ISO9001