Pelco C1629M-F manual Rack Mounting, To install the DVR5300 in a rack

				xt
				Te
			RE	ple
				Sam
			V
				t
				ex
		0	S	T
		0	LT	ple
Model		2	O m
		2
		0
		-	V	a
		9
		3		S
		-
		7
		6
		3
		0		xt
				Te
			PS le
			M p
			A	Sam
				Z
	L		FREQ	0H
	MODE	SN		50
				/6

s u t a r a p p A o e d i V / o i d u A

A

S

U

IN

DE

MA

A C , S VI O L C , O C EL P Y B G F M

K K 1 9

PRODUCT LABEL

Figure 8. Product Serial Number Label

RACK MOUNTING

The DVR5300 mounts into an industry-standard 19-inch (48 cm) equipment rack. The DVR5300 occupies 3 RU (rack units) of vertical rack space (5.25 inches or 13.3 cm). The hardware necessary to mount the DVR5300 into a rack is supplied with the unit.

The rack must meet the following requirements:

•19-inch (48 cm) EIA-310-D compliant (rear column required)

•Rack column depth: 24 to 30 inches (61 to 76 cm)

•Column-mounting hole provisions: 10-32 UNF-2B threaded holes or square window holes on front and rear columns

•Door systems are acceptable. Front doors must have at least 2 inches (5.1 cm) between the DVR5300 front bezel and the inside of the door. Rear doors may only be used on rack columns that are more than 26 inches (66 cm) deep.

WARNINGS:

•Secure the front and rear screws to the support rails.

•Make sure the DVR5300 is level.

•Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do not block these openings. Never place the unit near or over a radiator or heat register. When placing the unit in a rack, be sure to provide proper ventilation.

To install the DVR5300 in a rack:

NOTE: Figure 4 on page 11 identifies each piece of hardware for this procedure.

1.If chassis mounting brackets are not attached: Attach one chassis mounting bracket to each side of the DVR5300. Use six 10-32 x 0.25-inch Phillips pan head screws for each bracket.

C1629M-F (3/08) 15