Reassembling the Unit
1.Replace the chassis cover using the screws you removed from the sides and rear of the unit (refer to Figure 14).
Figure 14. Replacing the Chassis Cover
2.Attach the silver product label that came with your upgrade kit to the inside of your DVR’s front door.
a.Remove the paper backing from the product label.
b.Carefully place the label,
c.Press down firmly to ensure that the label properly adheres to the inside of the door.
NOTE: In the event that your unit or its components require service, specific labels must be present and appropriately affixed to the unit’s door. Pelco product support personnel use these labels to identify the exact components installed in your system. A separate product label is required for each upgrade component installed on the DX4500/DX4600.
3.Reinstall the unit in a rack enclosure if necessary, and reconnect all of the cables and peripheral equipment you removed earlier.
4.This completes the reassembly of the DX4500/DX4600.
5.To complete the HDD installation, refer to Formatting on page 16.
C2676M (9/07) | 15 |