68 EN |
TV Brand Setting
When programed (set) with a manufacturer’s (brand’s) code, this Remote can perform some of the remote control functions of the listed TVs. You can control a JVC TV without setting a brand code.
1 Turn on the TV
Turn on the TV using the Power button on the TV or its Remote.
23- 1,3
4
VCR CABLE | TV/VCR |
TV /DBS |
| 4 |
3- 2 4 | ENTER |
Number keys |
3- 3
TV VOL +/–
2 Set remote operation mode
Set the VCR/TV/CABLE/DBS selector to “TV”.
3Set TV brand code
Follow the example shown below.
1Press and hold POWER.
2Press the Number keys to enter your TV’s
brand code by referring to the table below.
3Press STOP ( 7 ), and release POWER.
●Once you have set the Remote to operate a TV, you do not have to set it again until you replace the Remote’s batteries.
●JVC and PANASONIC have two codes. If the TV does not function with one code, try entering the other.
4Operate TV
Press one of the following buttons: POWER, TV/
VCR, TV/VCR CH +/–, (TV Muting), TV VOL +/–, and Number keys.
●For some brands, you must press ENTER after having pressed the Number keys to enter a channel number.
●To operate the VCR, set the VCR/TV/CABLE/ DBS selector back to “VCR”.
TV BRAND NAME | BRAND CODE |
JVC | 01, 03 |
HITACHI | 10 |
MAGNAVOX | 02 |
MITSUBISHI | 03 |
PANASONIC | 04, 11 |
RCA | 05 |
SHARP | 06 |
SONY | 07 |
SAMSUNG | 12 |
SANYO | 13 |
SEARS | 13 |
TOSHIBA | 08 |
ZENITH | 09 |
|
|
NOTES:
●Depending on the type of TV, some or all functions cannot be operated using this Remote.
●It is impossible to control a TV that does not have a remote sensor.
(Ex.) To set Remote to RCA 05:
POWER | AUX | STOP |
|
| JKL |
Hold | Press in succession | Release | |
down | |||
|
|
68 | 1/22/3, 5:45 PM |