Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom | Cause | Correction | |
|
|
| |
No power. | The power cord is disconnected. | Plug the power cord into the wall outlet | |
|
| securely. | |
|
|
| |
The power is on, but | No disc is inserted. | Insert a disc or tape. (Check that the | |
the DVD+VCR does not | No tape is inserted. | disc or tape indicator in the display | |
work. |
| window is lit.) | |
|
|
| |
No picture. | The TV is not set to receive DVD+VCR | Select the appropriate video input mode | |
| signal output. | on the TV so the picture from the | |
|
| DVD+VCR appears on the TV screen. | |
|
|
| |
| TV/VCR mode for DVD+VCR is set to | Press the TV/VCR button on remote | |
| TV. | repeatedly to choose VCR mode. VCR | |
|
| indicator light appears in VCR front | |
|
| panel. | |
|
|
| |
| The antenna or video cable is not con- | Connect the antenna or video cable | |
| nected securely. | securely. | |
|
|
| |
| The connected TV power is turned off. | Turn on the TV. | |
|
|
| |
No sound. | The equipment connected with the | Select the correct input mode of the | |
| audio cable is not set to receive | audio receiver so you can listen to the | |
| DVD+VCR signal output. | sound from the DVD+VCR. | |
|
|
| |
| The audio cables are not connected | Connect the audio cable securely. | |
| securely. |
| |
|
|
| |
| The power of the equipment connected | Turn on the equipment connected with | |
| with the audio cable is turned off. | the audio cable. | |
| The Digital Audio Output is set to the | Set the Digital Audio Output to the | |
| wrong position. | correct position, then turn on the | |
|
| DVD+VCR again by pressing POWER. | |
|
|
| |
The playback picture is | The disc is dirty. | Clean the disc. | |
poor. |
|
| |
| Tape heads are dirty. | Clean video heads. | |
|
|
| |
| Tape is a rental or was recorded on | Use TRK | |
| another VCR. | adjustment while tape is playing. | |
|
|
| |
The DVD+VCR does | No disc is inserted. | Insert a disc or tape. (Check that the | |
No tape is inserted. | disc or tape indicator in the display | ||
not start playback. | |||
| window is lit.) | ||
|
| ||
|
|
| |
| An unplayable disc is inserted. | Insert a playable disc. (Check the disc | |
|
| type, color system, and Regional code.) | |
|
|
| |
| The disc is placed upside down. | Place the disc with the playback side | |
|
| down. | |
|
|
| |
| The disc is not placed within the guide. | Place the disc on the disc tray correctly | |
|
| inside the guide. | |
|
|
| |
| The disc is dirty. | Clean the disc. | |
|
|
| |
| The Rating level is set. | Cancel the Rating function or change | |
|
| the rating level. | |
|
|
| |
The remote control | The remote control is not pointed at the | Point the remote control at the remote | |
remote sensor of the DVD+VCR. | sensor of the DVD+VCR. | ||
does not work properly. | |||
| The remote control is too far from the | Operate the remote control within 23 ft | |
| DVD+VCR. | (7 m). | |
|
|
| |
| There is an obstacle in the path of the | Remove the obstacle. | |
| remote control and the DVD+VCR. |
| |
| The batteries in the remote control are | Replace the batteries with new ones. | |
| exhausted. |
| |
|
|
|
34